Recent content by jmill00

  1. J

    drawbar

    Right you are Todd, Thanks much. I use eBay for the vintage motorcycles I work on, but for some reason never thought to look there for tractor parts. Jack
  2. J

    drawbar

    Somehow I lost the drawbar off my 1973 IH-674. I've searched the fields and pastures where it might have fallen off with no luck. Does anyone know of a used parts supplier who may be able to help. If that doesn't work, can someone give me the measurements and hole diameters so perhaps I can get...
  3. J

    574/674 200 Gas needs manifold

    One more question. I need the torque and tightening sequence for the manifold bolts. I get really nervous around cast iron. I assume you tighten in steps from the center out just like the head, but it never hurts to ask the experts.
  4. J

    574/674 200 Gas needs manifold

    I'm not a welder so I think I'll order the manifold and the muffler and take them to a muffler shop and se if they can figure a way to mate the two. Thanks for responding.
  5. J

    574/674 200 Gas needs manifold

    I am in desperate need of a manifold for a 1973. Mine is cracked. YT has a manifold, but it is for a vertical muffler and mine currently has a horizontal muffler going out the back. No problem with cutting a hole in the hood and switching, but YT doesn't have the piece that goes between the...
  6. J

    1973 IH 674 Valve kit

    Thanks Cliff, That's what I was looking for. I am about ready to start troubleshooting and wanted to be sure the parts were available before I dug in. Do you know if that $182.67 is the retail or wholesale price. Probably double that from the dealer if it's wholesale.
  7. J

    1973 IH 674 Valve kit

    Not really sure, but I'm am pretty sure at least one valve is hanging up until the engine gets really warm. Loudly clicking from the valve cover area. I would say it was a bad hydraulic lifter only it doesn't have hydraulic lifters. The clicking goes away after it warms up, but it still doesn't...
  8. J

    1973 IH 674 Valve kit

    Does anyone know of a good source for a valve kit. Valves, Guides, Springs, clips and gaskets. The dealer wants over $500 just for the parts (Aftermarket not IH) and I was hoping to spend a little less than that. IH 674 with C200 gas engine
  9. J

    IH 574/674 Gas

    Excellent, that's exactly what I needed. Thanks much.
  10. J

    IH 574/674 Gas

    I think the engine is a model 200. Not sure though. what I'm curious about is how to determine which distributor I have so I can order a solid state ignition upgrade. Also, does anyone have any suggestions on suppliers for these kits?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top