(800) 853-2651
SHOP NOW

Recent content by jngreen

Yesterday's Tractor Forums
  1. J

    Oliver 88 serial number question.

    Not sure which block, how do I tell? I assume its stamped on the block. I assumed the motor is correct to the tractor because of the freeze plugs and I bought it complete and running, minus some of the sheetmetal. It basically only has a hood and rear fenders on it.
  2. J

    Oliver 88 serial number question.

    Serial number on my 88 oliver is 120449. What exactly does that mean, and does it make it more rare or valuable? The best I can come up with is that its a 1948 model, and it may be a Streamline instead of a Fleetline. Someone told me there was a small amount of them made, and I have the correct...
  3. J

    Oliver 88 manifolds

    thank you, now I know what parts to look out for.
  4. J

    Oliver 88 manifolds

    So I should look for a 1650 exhaust manifold then? Cool, I can do that. I don't know the exact year of my 88, I have it in my head that it is a 48 or 49 for some reason. I am looking for a better breathing intake manifold because I am getting a lot of condensation and sometimes frost on the...
  5. J

    JD 410b help please

    Definately not a brake issue, although the brakes also need attention. It is steering related, it will completely turn the wheels to the left when stopped, although the steering wheel stays put. The engine laboring at idle is a bigger concern to me because I do not want to damage the pump...
  6. J

    JD 410b help please

    I do not believe the steering valve is causing the engine to labor. It does not turn harder one way or the other, it turns easily both directions actually. It will turn the wheels to the left constantly and at the same rate. It is pretty easy to keep straight if you steer to the right at the...
  7. J

    Oliver 88 manifolds

    I have a cracked exhaust manifold. Is there a manifold that would be considered an upgrade to my worn out factory piece? Looking for something that might increase flow. Same goes for the intake manifold. Its going on my puller. thanks, Josh
  8. J

    JD 410b help please

    I have recently acquired a 410b for the farm that has a couple of problems. First, it wants to steer to the left constantly. You have to keep steering to the right to keep it straight and if you don't it will return to full chock left within 10-15 seconds. Next, it acts like it is under a load...
  9. J

    Need to find driveshaft for 560 D injection pump.

    Thanks for your help, I"m gonna call around some more. I found that Scheid diesel has the cheapest so far and they are close to me here in Indiana.
  10. J

    Need to find driveshaft for 560 D injection pump.

    My old injection pump locked up and broke the drive shaft. I have a used pump that is supposed to be good so I need the driveshaft to see if the old 560 is gonna run. IH dealer is pretty proud of that little shaft ($300). Hopefully someone has a good used one they want to get rid of. Or maybe...
  11. J

    560 diesel pump

    where can I find a replacement driveshaft? I have a 560 that sheared one, I have another pump to try cause the original is still locked up. Now I need to replace the driveshaft.
  12. J

    12 volt conversion

    please explain.....
  13. J

    12 volt conversion

    Well, what do you know, I am actually north east of Indy about halfway between Noblesville and Elwood along S.R. 37. Bedford would be almost exactly 100 miles from my house, maybe a little more, so prolly not gonna drive down there a couple of times for a genny rebuild. Thanks for your help on...
  14. J

    12 volt conversion

    Correct, my tractor is currently 6 volt positive ground. I don't think there are any decent alternator/ generator rebuild shops in my area (central Indiana) so converting to an one wire alternator and switching polarity is probably the cheapest/easiest route. I believe I can get a reman...
  15. J

    12 volt conversion

    My 88 is currently running a six volt electrical system. I would like some info on the conversion. Also, didn"t I see a kit on this site for the 88 Olivers that included the alternator, brackets, resistor for the coil, and some instructions? I can"t seem to find it now, so I must have been...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top