(800) 853-2651
SHOP NOW

Recent content by JoeR83

Yesterday's Tractor Forums
  1. J

    44 A Starter Band

    That and in addition to something else... fibrous, a very distinct cross pattern. That being said though since it is 80 years young...it could have been installed by someone if it isn't supposed to be there. However, Steiners breakdown picture of the band does show something there, although...
  2. J

    44 A Starter Band

    Working on my 44 A. I had removed the band around the end (away from the nose) of the starter. There was some 80 year old material between the band and the starter housing...can anyone tell me what this material is supposed to be? It's very brittle and will be going in the trash. I'd like to...
  3. J

    Rear cover/rockshaft removal JD A

    I'm looking to swap rear covers from a 52 to a 44 A. The 44 has a power lift and PTO mounted, the 52 has a power trowl and PTO mounted. I know the hydraulic assemblies would go, but if I just unbolt the rear cover and attempt to remove, will the PTO come out without fighting me or will I need to...
  4. J

    44 A Oil Pressure Gauge and Settings

    Hi all, fairly new here, I posted awhile back on getting my 44 A running. Finally got it started this afternoon! It hadn't run in 15-20 years, been working on it since June. Little time here and there between work and young kids finally got it to fire up. Anyways...on to the question that I...
  5. J

    Working on a '44 Model A

    Yes, this has 10-12 ports on it and I did get the correct bits to clean them out. There are definitely a few little things on this that need special attention!
  6. J

    Working on a '44 Model A

    I will definitely pull plugs and see if there is anything in there along with checking the valves, as I was going to adjust them as well. I will say this is my first go at anything 2 cylinder related, including a carb rebuild. I've watched a few videos, looks like a fairly straightforward...
  7. J

    Working on a '44 Model A

    The fuel tank is actually very clean. No rust or varnish...bright silver. So that's a huge plus. The small tank on the other hand, not so much, but I'm just going to cap that one off anyways.
  8. J

    Working on a '44 Model A

    Hi all, new poster here, been reading for some time to gain some knowledge but have some questions for the experts here. I recently acquired my late grandfather's 1944 A and am working on getting it running. A little background here so hopefully this helps...as far as I know, this tractor...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top