Recent content by JV Texas

  1. J

    IH 424 how to rebuild a carburetor

    I have just recently bought a IH 424 "gasser". It ran fine but you could tell that maybe the carb needed some cleaning. Well, now its running alot rougher and I want to fix it. I have rebuilt the carbs on old 8n"s before, so I think I can do this one, but would like to have some step by step...
  2. J

    International 424

    what is a two stage clutch? My current tractor is a 49 8N....
  3. J

    International 424

    I have found a 1970's era International 424, 40 hp tractor with less than 1000 hours on it. It has a new seat, power steering and independent PTO. Can anyone give me the worth of this tractor? Are there any sites like the Kelly blue book that gives the wholesale/retail prices on tractors? Thanks..
  4. J

    8n motor

    my 8n suddenly has water in the oil. Is there anything other than a busted block, busted head gasket or head that might cause this? I"ve taken the motor down to removing the head and the gasket looks good. Just want some input before I preceed with the overhaul. thanks
  5. J

    pto seal leaking

    no, i did not replace the bearings... how do i tell if they are bad?
  6. J

    pto seal leaking

    its an old '49 8n ford
  7. J

    pto seal leaking

    I replaced the pto seal and it held for about three months, then started leaking again. Is there something I'm not doing here? Should I have the shaft looked at? Any info would greatly help! thanks
  8. J

    5' mower blade, one piece

    I have an old F&F finish cut mower with a 5" blade that I broke. Does anyone know where I might find one out there?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top