(800) 853-2651
SHOP NOW

Recent content by Keith0723

Yesterday's Tractor Forums
  1. K

    410b swap to 276 engine

    If the engine bolts up I think with parts from both backhoes I can make it work. Thanks for the info
  2. K

    410b swap to 276 engine

    I meant 410c
  3. K

    410b swap to 276 engine

    Thank you. I would be pulling the 276 out of a 310c so I would have all the accessories. As long as the motor bolts right up I should be good? Anything else that may stop this from working? Thanks
  4. K

    410b swap to 276 engine

    Its a John deere 410b backhoe
  5. K

    410b swap to 276 engine

    I have a 410b with a bad 219 engine. Will a 276 engine bolt in my 410b? I've searched and believe it will fit just wanted to double check with the pros on here. If it does drop right in is there any other info that I may need to know about doing this swap? Thanks guys
  6. K

    John deere 410b oil pressure

    Thanks
  7. K

    John deere 410b oil pressure

    Thanks guys, that's not what I wanted to hear. I need those books before I do anything. Can the oil pressure be adjusted? Oh and mechanical oil gauge I have
  8. K

    John deere 410b oil pressure

    Thanks jim. The oil light came on so I bought a new gauge to check pressure. Can the bearings be replaced while engine still in tractor? I will purchase a master gauge and books. Thanks again.
  9. K

    John deere 410b oil pressure

    Hey guys I have a jd 410b with a 219 diesel.Is there an adjustment for the oil pressure? My pressure when i start up is around 35 and when warm it's down to almost 0 using 15-40 oil. Would a pretty good leak in my pan gasket cause this? I've done so much work on this engine and hope it's not...
  10. K

    John deere 410b destroking valve

    Thank you wore out. I noticed today that when I curl the bucket it put a noticeable strain on the engine. I'm going to start with that. Thanks again
  11. K

    John deere 410b destroking valve

    Hey guys I'm back. I can not figure out why my 410b wont start when hot unless I wiggle steering wheel. Wore out (member here) mentioned an internal leak somewhere but don't know where to start looking. Are there other relief valves other then the one on pump? Any help is appreciated.
  12. K

    John deere 410b destroking valve

    Ok so the pump number I posted is just the housing. Jdparts says my pump is ar96175 but how do I know what pump is in my deere? The only number I found was just the housing #.do you guys know if I can put a destroking solinoid in this pump and plug in to my existing harness? Sorry for all the...
  13. K

    John deere 410b destroking valve

    Another question. Jdparts is asking for pin/serial #. Is that one frame or motor? My frame is t0410bf720224 and nothing came up.
  14. K

    John deere 410b destroking valve

    Will do thanks. The pump in it now is r71889 which I believe is original. Heading to jdparts now. Thanks
  15. K

    John deere 410b destroking valve

    Thanks TX I have number 15 in your link. Why all of a sudden do I have to turn destroking valve to start and then turn it out? Is there something that I can replace or fix. I believe it is all original pump. R71889. Heading to jd parts to see if that is the original pump. Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top