(800) 853-2651
SHOP NOW

Recent content by ken spenceley

Yesterday's Tractor Forums
  1. K

    MF 202 with 100 series loader

    I have filled mine to 9 inches from the top and this seems to work okay. It would still be interesting to know how far down the full mark is on your dip stick. Thanks very much for response. Ken Spenceley
  2. K

    MF 202 with 100 series loader

    Thanks very much for the picture of your Mf202 loader. From the dimensions you gave and the picture showing the location of filler opening ( which is lower than mine )I was able to determine the full level for the oil. Again , thanks a lot for your help. Ken Spenceley
  3. K

    MF 202 with 100 series loader

    Thanks very much for your reply. I looked for the drain plug that you mentioned but I do not see one but my service manual for this loader says there is a dip stick on the breather/filler fitting that I think has broken off. Can you give me an accurate measurement from the top of the upright (...
  4. K

    MF 202 with 100 series loader

    I have had the above tractor and loader for only a short while and think that the loader is low on hydraulic oil. The manual for the loader says that there is a dip stick in the breather/ filler opening but there is not. ( probably broken off ) I measured down from the top to the oil level and...
  5. K

    MF 202 Power Steering System

    I am proceeding to replace the hydraulic line between the right hand hydraulic cylinder and steering column area . The cylinder connection is straight forward but the steering column area connection seems almost impossible to access. Is there a way to access these connections without a lot of...
  6. K

    MF 202 power steering lines

    Have been working on the power steering system and need to replace on of the lines from the hydraulic cylinder to the steering column area. The connection at the cylinder is easy but the connection at the steering column area is very very difficult without taking a lot of parts off. What is the...
  7. K

    MF 202 Power Steering System

    I have recently purchased the above tractor and experiencing a problem with the power steering. ( it quit working and very hard to steer ) Checked the pump reservoir and there was very little oil in it. There was some whitish foam on the inside of the reservoir cover. I suspect that the wrong...
  8. K

    massey harris 30 governor

    Thanks very much for the prompt reply to my question on the bumper spring adjustment. I also have a question on the adjustment of the rod between the governor arm and the carburetor. My shop manual states that the length of this rod is adjusted, initially, so that the throttle butterfly is wide...
  9. K

    massey harris 30 governor

    I have taken this Novi fly ball governor apart and it appears to be in good condition. I notice there is a adjustment on the the bumper spring. I would like to how this is done. I have looked in the manual and other places , but they do not address this issue. Help with this would be...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top