(800) 853-2651
SHOP NOW

Recent content by KennyMac41

Yesterday's Tractor Forums
  1. S

    Tach Rotation

    I bought a new cable for my tach, I cleaned up the old one and it turns freely but when I hooked it up it tries to turn backward. I can check it with a reversible electric drill and it works as it should so I know the tach is working as it should. Is there some sort of reverser that is supposed...
  2. L

    CARB

    Have a wd45 and run the carb rich for a higher RPM do you think it would pull better like that or go back to standard setting ?
  3. L

    when to replace concaves

    I have a Case IH 1420 combine with 1/4 inch bar stock concaves. They key bars seem to be getting a little rounded on the threshing edge. I combine corn and soybeans with this machine. Used it last fall and it seemed to thresh ok. I am wondering at one point it is necessary to replace...
  4. D

    Diesel surprise

    When out to see if my diesel tractor would start. "It did" no heater and no starter fluid and 2 degrees out.
  5. J

    4020 orings in block for sleeves

    Installing new sleeves & pistons in a 4020,when removed the red oring was in top groove and black in bottom. Deere service manual says other way. Which is right?
  6. S

    Engine Overhaul

    Got the crank back, new pistons and liners done and going back togther.
  7. D

    Need advice on tie downs for Bobcat

    in need of advice.I just recently bought a bobcat m610 and I am a little concerned on how I can tie it down on my trailer. It has brackets on the rear to chain too but nothing on the front. would chaining it down to the loader cross frame work or does someone have a better way. I will be...
  8. J

    550 PTO shaft bearing

    I need to replace the "O" ring on the PTO shaft to coupling. I read here that by removing the hydraulic unit (top of trans) that the coupling pin can be removed and the output shaft and coupling pulled out to get at the "O" ring. I have already changed the bearing retainer seal and added a...
  9. D

    TO 30 rear end oil ? And 12 volt conversion

    I?m wondering how much gear oil the rear end hold for the 3 point hitch and transmission. And mine is positive ground and has a 6 volt battery in it and a 12 volt generator I need a battery I want to make it negative ground what can I do to use the generator for now I bought a 12 volt coil for...
  10. K

    Tractor shuts down

    Thanks for the imput, have tried a couple things, one the gas cap, that did not seem to be the problem. The coil issue sounds like it could be the cause, but this one is new, and the one that it replaced was a couple months old. I have heard to wrap the coil in tin foil, any one tried that one? km
  11. K

    Super C electrical

    I am restoring a Super C that was partially dismantled when I got it. Question 1 is this tractor positive or negative ground. Also there is mount bracket that holds the front cowling, and is bolted into the neck of the upper radiator outlet, is there a bracket that goes between the mounting...
  12. K

    Tractor shuts down

    I have a 49 8N that has been giving me fits for the last year. We have replaced EVERYTHING electrical, changed carb, gas line, and sediment bulb. The problem, after running without missing a beat, the tractor starts shuting down. This occurs when running a 60" finishing mower, this week after...
  13. K

    Carburator setting

    What is the correct setting on the carb for 1949 8n?
  14. K

    Radiator caps for 49 ford *N

    I have noticed that two caps are offered, one is 4psi (a standard cap) and one is the decorative original type that is 12psi, which one is recommended?
  15. K

    Temp gauge adapter

    Wasn't aware there was a place on the head. The adapter I purchased is from Yesterday, fits in the upper hose, clamped on both ends, Metal pipe type with fitting for the sensor
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top