Recent content by kermkep

  1. K

    ZB front end change

    How hard would it be to change a tricycle front end to an adjustable Wide front end on a 1953 ZB? Also, How hard are they to find? Thanks for any information.
  2. K

    Removing 3.152 engine

    Hey minor09, You were right. I finally found the bolt that held the starter on went through the starter, then the engine block. and threaded into the bell housing. As soon as I took the starter off the engine and transmission came apart just as I expected them to do. Thanks for your input. I...
  3. K

    Removing 3.152 engine

    I have started to remove the 3.152 3 cylinder gas engine from my 1974 mf 135. From what I can see everything is disconnected and ready to come a part. I'm having trouble getting the engine to come a part from the transmission. Is there something that I could be missing? It looks like I have all...
  4. K

    Parts

    Could someone suggest a place to buy an overhaul kit for a 1974 MF135 with a Perkins 152 gas engine? Maybe parts of any kind for that tractor. Thanks in advance for your help.
  5. K

    heat shield for MF 135 with Perkins 3 cylinder gas

    I too would like to see a picture of a heat shield for a 135 3 cyl. gas. When mine gets good and warm it will just dies as if the switch was shut off. After it sits for a few minutes it will run again until it gets too warm again. Thanks in advance.
  6. K

    Top radiator hose

    I don't believe you would need to take the fuel tank off to replace the radiator hose. I also think if you would lubricate the hose it would go on easier. I have that same tractor and I've had the fuel tank off twice. There is a bolt on the front right hand side as well. If you'd like to e mail...
  7. K

    Z steering wheel

    I found one. Thanks for the reply. If something happens I'll get back to you.
  8. K

    Z steering wheel

    I'm having trouble finding a cast steering wheel for a M&M Z. Does anyone know where I might find one? Thanks
  9. K

    zb mm hydraulics

    I have a couple hyd. pumps and 2 or 3 tanks, and I think I have a set of steel lines that go to the back. I bought a ZB a while back and these extra parts came with it. I live in south central Kansas if it's not too far.
  10. K

    MM tumble Bug Plow

    Does anyone know if there are new springs available? They look to be in bad shape. I will continue to work on the latches. They are still not easy to move. Thanks
  11. K

    MM tumble Bug Plow

    I am hoping someone can give me some ideas about how to get my plow to lock in the up position when I pull the rope at the end of a the field. Right now it will turn over but will go on over to the plowing position going the other way. I know very little about it and it has been sitting quite a...
  12. K

    ZTU Radiator

    Thanks for all the suggestions. Yes the mix in the radiator is a 50/50 mix. I'll look at all the other things and make a reply when I find the problem. Thanks again.
  13. K

    ZTU Radiator

    What degree thermostat should be in this tractor?
  14. K

    ZTU Radiator

    I have a 1944 ztu. When I run it long enough to get good and warm, not hot, the radiator looses coolant out of the overflow shortly after I shut it off. It runs good other than that. Does someone have an idea as to what might be causing this. Also is this a pressurized system. There is never...
  15. K

    MF 135 misses at high rpm

    After changing the condenser, coil, and fuel line it seems to have corrected the problem. I had tried a used condenser and coil that I had but had no success. Finally got new parts all at the same time so I don't know for sure what fixed the problem. Thanks to everyone for their suggestions.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top