Recent content by KRS

  1. K

    wondering how much it weight

    283 is the engine. Look for a model/serial number on a plate on the side of the transmission.
  2. K

    Farmall H wont start

    Thanks for the ideas. I will be working on it this weekend. KRS
  3. K

    Farmall H wont start

    I am trying to help my brother in law fix his H. It was running good and just stopped, wont fire. We put in new plugs, points, condenser and plug wires. Still does not fire. Tried a new coil, no change. We pulled a plug and turned it over to look for a spark. Once or twice I saw a very small...
  4. K

    super m670 horse power

    They are 74 HP at the PTO. http://www.external_link/farm-tractors/000/9/7/974-minneapolis-moline-m-670.html
  5. K

    Penetrating oils, is one better then the other?

    Our neighbor worked on tractors and old single cylinder engines. When he had a stuck engine he would heat up lard to the point that it was boiling. He would pour the boiling lard on top of the pistons. After letting the lard work for a minute or two he would rock the tractor while in gear and I...
  6. K

    G100? on Ebay

    It looks like a GVI or a G704.
  7. K

    M670 Super Hydramotor

    My 670 Super steering was acting like you describe. I replaced the relief valve on the back of the power steering pump and the problem went away. The problem reappeared a few months later. The fluid was very dark and smelled burnt in the PS system. I flushed the system and I replaced the fluid...
  8. K

    how far forward with loader

    For heavy work, I would keep it close. With the bucket on the ground, I would have the back of the bucket about 12" away from the tires. On the tractor I load manure with, I have it about 24" away so I can get a little more reach dumping into the spreader. All of this varies depending on how far...
  9. K

    gb propane

    If external_link is correct, the GB LP is rated at 1100 RPM. I did not think it was that low, but I know the G and GB tractors engines ran fairly slow.
  10. K

    moline pullers help !!!!!

    This would be a good High School Physics problem! I understand what you are saying, if the front wheels are barely touching the full weight of the tractor is on the rear wheels. The drawbar acts as a lever, the longer the draw bar, the easier it is to lift the front of the tractor. I am not sure...
  11. K

    wide for narrow

    Where are you located? I have a ZBU, maybe we could work out a trade. KRS
  12. K

    Correct red for wheels?

    It is called Cherry Red. Here is the paint reference from the MM website: http://jetstar.minneapolis-moline.com/paint_info/LetteredSeries.pdf Here is the main paint page with more information: http://jetstar.minneapolis-moline.com/paint.html
  13. K

    paint codes

    Here is the paint reference from the MM website: http://jetstar.minneapolis-moline.com/paint_info/NumberedSeries.pdf Here is the main paint page with more information: http://jetstar.minneapolis-moline.com/paint.html
  14. K

    Bronze Metallic Paint

    Here is a link to paint info; http://jetstar.minneapolis-moline.com/paint.html Here is the company that sell the paint; www.equipmentcolor.com KRS
  15. K

    MM website message board problems:

    http://www.minneapolis-moline.com/
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top