(800) 853-2651
SHOP NOW

Recent content by Larry Lambert-HT

Yesterday's Tractor Forums
  1. H

    193 bottom plow

    Hey guys, what is the difference in a A193 plow for super a, and a 193 plow for a cub. They look the same to me.
  2. wh

    Farmall H extra hyd reservoir

    Hopefully pic shows a decent view. Mounted to top axle. Hyd controls above tank. Tank holds 7 gallons. Besides the filter in return line, there is a strainer/filter in tank where suction line connects. Purchased controls, filter, and strainer from surplus hyd. . Converted from belly pump to...
  3. 8

    7020

    Does anyone make new radiators for my 7020 Allis?
  4. P

    Good clamp electric meter

    Given today is prime day on Amazon, thought maybe I could find a desk on a clamp meter. Normal household use and tractor wiring use. Recommendations?
  5. G

    JD 2150 Ignition Switch Wiring

    Looking for some help replacing a bad ignition switch on a 1985 JD 2150 Tractor. There was 5 wires going to the switch and I have identified only the BAT cable. The old defection ignition switch has no labels on any of the pins. The old switch had 6 pins but not all were being used. The new...
  6. J

    1963 John Deere 1010c gas engine

    After doing a test fit with my hood I noticed it looks like a strip of trim or something was once there. I don't see anything in the book. Any thoughts...
  7. B

    Weak spark on EI Ignition

    134 Gas Engine. Engine was running fine then died. Very weak spark to plugs. Swapped coil to another one I had and no change. 12V to coil from battery. EI pulses current properly. Wire from coil to distributor gives weak spark when grounded with both coils. I would assume that I should be...
  8. grandpa Love

    Split Cub

    Bought this with a bad clutch, had a good used one out of a parts machine. Easy swap.... Nope! throw out ' bearing ' was missing chunks and the brass bushing was shot. Waiting on parts.
  9. Geo-TH,In

    Have you seen a thermometer like this?

    Liquid thermometer says its 72 Digital says its 74. I put the thermometer outside. It's cold outside. The density of the cold liquid has all The glass bulbs floating. Lowest reading is 64 degrees. I thought of sharing because the thermometer works like antifreeze and battery testers...
  10. D

    Couldn't let it go...

    to the scrapper. This P&W shaper was in a buddy's shop when he passed away several years ago. When his place cleaned out it moved to another guy's shed for a few years, now he needs the room and it needed a place to go. 1910 vintage I think, still researching. I just have a soft spot for those...
  11. L

    Pull Type Massey 405 Combine

    Was wandering if anybody knows of one forsale ?
  12. Tom in Mo.

    McCormick 34-F24 Sickle Mower Pitman

    Any tips on acquiring a new bolt on Pitman for this mower? I know Tractor Supply and others have blanks but I might as well just carve one from an oak board.
  13. G

    Ford 2000 3 cylinder 4 speed PTO shaft

    This post was edited by Grtaylor on 06/23/2022 at 06:49 am.
  14. J

    Hub identify

    What are these hubs from? I get about 2 3/4 axle dia. The # 33761 A
  15. N

    1952 Ford 8N pto slipping out of engagement

    Greetings all, as of late my 52-8N has been slipping out of PTP engagement while using the Bush Hog only. It does not disengage on it's own while using other attachment's such as disc, rake Etc. any suggestions as too look at ? Regards
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top