(800) 853-2651
SHOP NOW

Recent content by LEE DOTSON

Yesterday's Tractor Forums
  1. L

    yes, starter can do that!

    My old 8 n had set for years and #2 was 0 comp. soaked in fluid for a few days, but had to remove cover to get into valves to break it loose
  2. L

    Wisconsin A.H.H. ENGINE

    THANKS FOR THE REPLY, NOW IF IT WILL JUST RUN
  3. L

    Wisconsin A.H.H. ENGINE

    Can someone tell Me the proper sparkplug for this old engine
  4. L

    Electric starter for Gibson

    What is the best way to hook up a electric starting system on a Wisconsin on a Gibson
  5. L

    QUESTION ABOUT GIBSON TRACTOR

    Did they ever make a Gibson with a hand clutch, off the wisconsin engine? I just got one and it looks original, or a good farm hook up. It has the D rearend and front axle
  6. L

    OIL FILTER FOR FERGISON TE 20

    THAT WAS A NAPPA 1107 FILTER
  7. L

    OIL FILTER FOR FERGISON TE 20

    What am I doing wrong? Today went to auto parts store after seeing on here that a Fram c135 or a NAPPA 1157 would fit My little TO20. Neither one no longer available. There must be something that will work on this engine
  8. L

    fergeson 20

    what visual things do I look for to see iFt tractor is a TO or a Te
  9. L

    OIL FILTER FOR FERGISON TE 20

    I see difrent posts about using either a Nappa 1010 or a Fram c3. Both of these are smaller in diameter, or dont that matter.
  10. L

    OIL FILTER FOR FERGISON TE 20

    Today tried Cut Rate, NAPA, AND CARQUEST. All said no longer available. I find this hard to belive as there is lots of old fergeson 20s around
  11. L

    OIL FILTER FOR FERGISON TE 20

    Can I get some cross references for Fram or any other type filter I can buy localy. This is one that goes up into bottom of oil pan Someone realy had a great idea when this was designed
  12. L

    front wheels for to35 Fergeson

    Any other wheels that fit this tractor? Mine are thin and not sure if enough left to repair
  13. L

    Quincy compressor

    Have a Quincy 120 volt that has worked great. Today it gets up to 50lbs fine and then motor starts to lug down,after 55lbs I belive it would stop itself. Any ideas where to start?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top