Recent content by levibaker1982

  1. L

    New Holland TS100 no start/crank

    Gotcha, appreciate the response. Yes I do use the PTO, I run a baler with this tractor. I’m about to the point of putting a push button on the dash…🤣 I didn’t check anything at the neutral safety switch other than jumping it out with a bare wire. It’s a pain to get to.
  2. L

    New Holland TS100 no start/crank

    Evening all, I have a New Holland TS100 that will not crank/start with the key. It did when I bought the tractor, then all of a sudden this started. You can jump it at the solenoid and it starts and runs fine. I have jumped out the neutral safety switch on top of the transmission, no luck...
  3. L

    1974 580B trans only has pressure in neutral

    Did you ever find the problem? I have a 580B doing the exact same thing.
  4. L

    John Deere 5100M Hydraulic Temp. Code

    Afternoon all, I’m working on a John Deere 5100M that keeps throwing a code (Ccu 1638.00) for hydraulic fluid overheat. Unplugged sensor started tractor (cold) alarm stops, but light stays on and still throws code. Hooked new sensor into harness not installed in tractor, still throws code...
  5. L

    John Deere 555 Track Loader

    Evening All, I’ve got a John Deere JD555 track loader, seems as if the hydraulic fluid is getting into the transmission. Trans was full, hydraulic tank was full, set for a month or so went to start it and noticed the transmission fluid was over full and the hydraulic tank was low. Anyone have...
  6. L

    Watch the video I’ve pasted the link to, this is what’s it’s about. Maybe it’ll help you. [MEDIA]

    Watch the video I’ve pasted the link to, this is what’s it’s about. Maybe it’ll help you.
  7. L

    Ford 5200 Fuel Tank

    Appreciate the info, the one I’m looking for is a C5NN9002AM. The one I’m looking for looks almost like a rectangular box. It’s on a Ford 5200 Row Crop, that’s just my luck…🤣
  8. L

    Ford 5200 Fuel Tank

    Spoke to them today, they don’t have that particular tank. They told me they couldn’t get it. They are good folks for sure, I bought a lot of parts from those guys. Appreciate the response.
  9. L

    Ford 5200 Fuel Tank

    Evening good folks, does anyone know of any place that makes an aftermarket tank for a Ford 5200? I believe the 7200 is the same tank as well. The NH part number is C5NN9002AM. Mine has been patched by the previous owner in one spot and I just repaired a fair sized spot on the bottom. I figure...
  10. L

    How Much Oil is needed in an Air Cleaner Oil Bath

    If you didn’t find your answer by now, those slits are your oil level. Just ran across the thread and thought I’d throw that in there.
  11. L

    Ford 8000 lower draft shaft replacement

    I appreciate the info, I’ve got a manual that should be here today. It looks fairly simple to do, I just wanted to make sure I wasn’t going to damage anything taking the parts tractor shaft out. As far as the operational one, really doesn’t matter it’s gonna have to be cut.
  12. L

    Ford 8000 lower draft shaft replacement

    Does anyone have any dos or don’ts when replacing the lower draft shaft? I would just replace o-rings and move on but someone has welded the right side of my operational 8000 due to I’m sure the splines being stripped. I do know the top cover has to be removed and have started that process on...
  13. L

    John Deere 4230 blower fan swith

    Here’s the SG #.
  14. L

    John Deere 4230 blower fan swith

    Yes sir, my apologies. I realized that after I posted the comment. I’ll get that in the morning for sure.
  15. L

    John Deere 4230 blower fan swith

    Yes, My switch does have numbers.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top