Recent content by Lynn Opperman

  1. L

    1952ar gear shift

    Thanks for the reply. Im not sure how to adjust the clutch pulley brake. Ill have to see if any of my books shows anything.
  2. L

    1952ar gear shift

    Hello! My 1952ar is hard to come out of gear at times. Way harder than it should when I want to change from the selected gear to , say reverse. It seems to be an issue that wasnt happening a while ago. Any ideas what might be causing this and how to proceed.
  3. L

    1950 Farmall MD starter question

    If I see something in there while I put the starter back in Ill let you know, and the original mashed spring looks like it got pinched from the spring over torqueing
  4. L

    1950 Farmall MD starter question

    Thanks for your timely reply. I understand why now. I appreciate your knowledge and thanks again. I might need more of your knowledge if I cant figure out why the spring is getting mashed.
  5. L

    1950 Farmall MD starter question

    Hey everyone! Im having some issues with the starter on my 1950 Farmall MD. The starter drive spring got mashed so I bought a new one. It worked great for about a week when it started to have issues again. The spring seemed to get caught again. I researched starters and found where the starter...
  6. L

    1952ar shift fork replacement

    Shaft splines
  7. L

    1952ar shift fork replacement

    Thanks for your help. I got the clutch shaft out and the replacement in but have to redo it because I think I have to realign the slides one more over. I m sure I m on the right track.
  8. L

    1952ar shift fork replacement

    Thanks ever so much for your help. I ll try removing the bolts and hopefully that will work. I ll keep you posted.
  9. L

    1952ar shift fork replacement

    I had removed the 4 bolts at the start hoping that s all I needed to remove but it only comes away a little as well. So as I was looking at the fly out diagram I see there is a snap ring holding the shaft in place so surmised I had to go through the clutch to possibly get to the internals. That...
  10. L

    1952ar shift fork replacement

    Hi Mark. Thanks for responding. So the clutch cylinder / drum just slides off the shaft with a little wiggling? I was afraid to put any pressure on it because it felt like it was hitt something about 3/4 of an inch from its running position.
  11. L

    1952ar shift fork replacement

    clutch shaft fork
  12. L

    1952ar shift fork replacement

    I said shift fork but it s the clutch fork. Same issue is that I can t get the clutch cylinder off.
  13. L

    1952ar shift fork replacement

    Hello! I need to replace the shift fork on my 1952ar John Deere. I ve removed the clutch internals but the clutch housing cylinder only come 3/4 of an inch out and no further. How does it come the rest of the way off?
  14. J

    Cub valves

    Got a project cub the other day. Engine is partially took apart. Head is off and oil pan is off. Block is still together though with valves, pistons, etc. I'm going to put a set of rings in just because it's already apart. How do I know if it needs a valve job or not?
  15. L

    starter removal

    Hi all! Thankyou all for your replies. I did have to remove the pulley housing to get the starter out. I hope it goes back in easy. If not I'll be asking for your input again. Once again I appreciate all your input.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top