Recent content by mac rusty red 1010

  1. M

    Farmall M charging issue - must rev engine for charge

    This is common on 12 volt conversions especially with the one wire set up. There are smaller o.d. pulleys, 60 mm rather than 80 mm available just for this issue.
  2. M

    f 1066

    Does a 1066 have glow plugs? thanks
  3. M

    Continental 350 utility primary fuel filter

    I've had a 350d and loved it. The outlet has to be on top of the last filter to get the air out. It will gravity flow fine if all is clean and open. I did have the shut-off valve in the bottom of the tank gum up enough once, which caused a flow problem.
  4. M

    starter for cletrax-bf avery a with a ixb3 engine

    thank you for getting that number it's just what I am needing
  5. M

    starter for cletrax-bf avery a with a ixb3 engine

    If you could I would really appreciate it ...
  6. M

    1948 Avery Model A

    Hi wondering if you could possibly send me the starter number for the Avery, sure would appreciate it
  7. M

    starter for cletrax-bf avery a with a ixb3 engine

    trying to find a starter to fit a bf avery a would any you know if a ford like 8n starter could work thanks
  8. M

    Plow question

    I have not plowed with a 3-point plow on a fast hitch. I would start as Jim said. But it always seemed to me on a fast hitch plow the down pressure always kept the plow from working right a dealer told me to take the 5/8 bolts out of the top of the fast hitch sockets where they go through the...
  9. M

    Mechanical TA Operation Question

    I have used the ta on my old 350 a lot the only time i hurt it is when I had it in low going down hill....
  10. M

    power steering

    on a 350 farmall that the power steering has been removed. what would be the best thing to do with the pressure hose? thanks
  11. M

    3 Postion Switch ( no dim)

    I agree probably just are hooked onto the rear light terminal. I would try to keep b and d working the dim is real nice when driving at night on the road and meeting a car no need to blind people.
  12. M

    300-350 flywheel

    will the flywheels from the 300 - 350 row crop tractors inner change with the utility models? thank's
  13. M

    350 flywheel

    Will an H flywheel work on a 350 c175? thanks
  14. M

    706 hydraulics

    Need help on my 706 hydraulics. The fast hitch, steering, and everything works great, but the auxiliary valve is very weak will only open the baler gate about a third of the way, and the wheel disc not even that much. Help, can something be causing this other than the aux. valve? Thanks for all...
  15. M

    2504 IH

    I wouldn't think the points would cause a problem just sitting. I'd rather think the condenser they can act like that. But be sure you have good gas flow through your carb. before spending any $$$.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top