Recent content by Mack69

  1. M

    Starter for a John deere 1020 gas tractor

    I replaced the starter on my 1020 tractor a few years ago with a Delco Remy starter and I had to rebuild it earlier this year and as of today it's done in again. I haven't torn it down yet but I suspect that the brushes are shot. I want to get a new starter but I would prefer not to go with a...
  2. M

    1020 gas tractor fuel filter

    I already drained the tank and removed it from the tractor and flushed it out good with a pressure washer and cleaned the stand up pipe.
  3. M

    1020 gas tractor fuel filter

    I'm pretty sure that the original lift pump was replaced with a newer one that doesn't have the sediment bowl. I'm not sure if John Deere even offers one now. I think that I'll just leave the filter out for now
  4. M

    1020 gas tractor fuel filter

    There is no sediment bowl on this one
  5. M

    1020 gas tractor fuel filter

    I know that the1020 gas tractor didn't come with a fuel filter. Should I install one on it and if so any suggestions. I put an automotive plastic clear fuel filter in the line to the lift pump but it seems to air lock the fuel line so fuel doesn't freely flow to the filter. Any help would be...
  6. M

    Radiator overflow tube on a John deere 1020 tractor

    Can someone tell me how the radiator overflow tube attaches to the radiator
  7. M

    John deere 1020 tractor idle

    At what rpms should a John deere 1020 tractor idle
  8. M

    Fuel gauge

    I just got a new aftermarket fuel gauge for my John deere 1020 tractor. After I installed it and got it wired up the gauge shows full when the tank is only half full. Any idea what might be wrong
  9. M

    Oil pressure light

    Yes I checked from the sensor to ground and got nothing. I'm probably going to replace the wire anyway. I've replaced all of the other wiring
  10. M

    Oil pressure light

    No those are fully insulated terminals so I couldn't but I did connect the wire that I used to test the socket to the bulb and the oil pressure sensor and the light didn't work so I'm pretty sure it is the sensor
  11. M

    Oil pressure light

  12. M

    Oil pressure light

  13. M

    Oil pressure light

    Should the tab on the top of the sensor be connected to ground
  14. M

    Oil pressure light

    Not at all
  15. M

    Oil pressure light

    The oil pressure light doesn't burn when I turn the ignition to acc on my John deere 1020 tractor. What could be causing this
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top