mEl's latest activity

  • mEl
    mEl replied to the thread Case 1270 power shift issues.
    As I expected, C3 clutch circuit has a problem, unless there is a problem with C3 pilot spool sticking, the oil is getting away either...
  • mEl
    mEl replied to the thread 1450 case dozer.
    Bryan, The 1450 dozers are good units but I would have someone who is very familiar look it over and run it to check the engine for...
  • mEl
    mEl replied to the thread Case Centennial Plow Shares.
    Going back more years than I care to remember, I went to the local blacksmith with my grandfather, and he put the shares in a forge and...
  • mEl
    Disconnect the clutch rod so the shaft can turn front, you have to look in the sideplate to get the fork in proper position to...
  • mEl
    mEl replied to the thread New water pump issue.
    If you want the plug that is in the old pump, get your acetylene torch, heat it red hot and let it cool, it will screw out easy.
  • mEl
    mEl replied to the thread Case 1270 power shift issues.
    The only thing that does not sound right on your diagnosis is that the hydraulics are good, a leak in the powershift causes the flow...
  • mEl
    mEl replied to the thread Case 530 gas governor.
    Most had Zeniths but I have seen Marvels and I much prefer them to Zenith, they're cast Iron and the bodies stay in good shape, I have...
  • mEl
    mEl replied to the thread Case 530 gas governor.
    This has been posted before on forum, but I must ask, does the rod that goes from the carb front to the arm near the fan move easy or...
  • mEl
    The Federal yellow could be ordered out of the factory, and the internet lists the option number for it, it was a color that was used by...
  • mEl
    mEl replied to the thread Case 2590.
    Roger has it right, you may be able to narrow the leak down by seeing if the lift works depending on which clutches are being used in...
  • mEl
    mEl replied to the thread Case 970 powershift issue.
  • mEl
    mEl replied to the thread Case 970 powershift issue.
    Spool position has a direct effect on C2 pressure as I stated before, the clutch spool MUST stop against the rear of the valve, if you...
  • mEl
    mEl replied to the thread Case 970 powershift issue.
    C2 circuit is getting rid of oil somehow, this may sound stupid but the first thing I would check is the clutch spool travel, the spool...
  • mEl
    mEl replied to the thread Case 530 stuck in a few gears..
    No, totally separate compartments.
  • mEl
    mEl replied to the thread Case 530 stuck in a few gears..
    As others have stated, you must work under the cover to get the forks in neutral or the cover will not come off, I have seen people pry...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top