-
MM-TX replied to the thread Opinions Solicited.my 2¢ - I don't like the idea of a foot switch on a table saw. This thread reminds me I need to change my old Craftsman right side... -
Sounds like you might take the “win” on this one! One kudo allotted. Hey, rr is gone so now you got one less guy to run you off the...
-
Here's a very slim possibility......there is a spring loaded spacer in the governor. It comes out of the center and pushes against the...
-
Point taken. Bulldog will be ordered.
-
MM-TX replied to the thread Trailer coupler broke.Since you had to ask are you really that confident you’re not putting anyone at risk when you can put a better one on pretty cheap.
-
Maybe it’s just me but repairs to a worn out coupler are not the route to go. I’m not going to subject my and others safety to a repair...
-
MM-TX replied to the thread These are so AI.From an old ad guy the simplified formula is Tell them what they want to hear Make that message simple to believe Make it easy to follow...
-
As we see in our recently over the top "culture wars". The gullible, often from laziness, will always be the mark. There is also a lot...
-
MM-TX replied to the thread These are so AI.Just a simple overview on my take - from an old guy. Many just have a strong resistance to any change. Sort of in the definition of...
-
MM-TX replied to the thread false advertising.AI gathers info gleaned from both correct and incorrect sources much faster than humans. It doesn’t know the difference it then presents...
-
I flew KC-130s in the Marine Corps as well as running a squadron airframes maintenance shop and am well versed in fuel cell venting and...
-
MM-TX replied to the thread Fuel Tank Rust Removal.As @Mark-Ia said. Don’t vacuum! I was not thinking about sucking fumes into a motor and sparks. Bad idea! Sorry.
-
MM-TX replied to the thread Fuel Tank Rust Removal.https://www.yesterdaystractors.com/R7949_Fuel-Tank-Screen_28918.htm This site is a good source for parts. That screen is available from...
-
MM-TX replied to the thread Fuel Tank Rust Removal.Welcome to YT. Only you know what it looks like inside. Here is my guess without my eyeballs on it. If it hasn't been open and full of...
-
-
MM-TX replied to the thread What happened to the post "Suggestions on parts and worn items on my 3 point lift".Interesting. New user scraped from original 2009 post. @NormanSavesTractors you were probably right.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy