-
Mule Meat replied to the thread Just free'd up my first "stuck" engine---what to expect?.If I were going as far as pulling the pistons. I would at least hone the cylinders and install a new set of rings. Using the old rings... -
Mule Meat replied to the thread Finally got a rototiller.Earthquake uses a stamped steel wheel with a treaded rubber band stretched over it for traction.
-
Mule Meat replied to the thread How late can plant grass/hay?.Here in SW West Virginia people plant grass year round as long as they're no snow on the ground. It will not geminate until the...
-
Mule Meat replied to the thread solar question.I have been told alot of stupid things over the years. Things like. You will never see a battery powered car on the roads. But they're...
-
Mule Meat replied to the thread 92 chev alternator.Sounds like you just bypassed the internal voltage regulator. 13.35 volts is low. It should be at least 14 volts when running...
-
Mule Meat replied to the thread solar question.Don't you know that AI is taking over a humans brain function? In a few more years a human will need AI to tell them how to use a spoon...
-
Mule Meat replied to the thread "Air Cannon" equivalent for small tires..Be it a lawnmower or a farm tractor. Would you want to put old dry rotted wore out tires on something that you were restoring?
-
Mule Meat replied to the thread Anyone Know What This Is? Old Plow Part?.Wood?? Well then I changed my mind.. Appears to be the rudder off of a Mississippi steam boat.
-
Mule Meat reacted to used red MN's post in the thread Anyone Know What This Is? Old Plow Part? with
Like.
??? Must have belonged to Paul Bunyon? :) When I zoom in on it I see wood grain. All non stainless steel or galvanized metal I have... -
Starter bolts are not a problem.
-
I told you wrong - it weighs around 1600 pounds. It's a Goodyear LSW1400/30R46.
-
Mule Meat replied to the thread Anyone Know What This Is? Old Plow Part?.May be wrong. But it appears me to be a spud for an old cable trencher.
-
-
Mule Meat replied to the thread Tired. . ..Horsepower doesn't matter. You could move an 80,000 pound semi up the Grape Vine with a 3 HP Briggs engine and not hurt it if you...
-
Mule Meat replied to the thread "Air Cannon" equivalent for small tires..I have dealt with a lot of these type of tires and I don't think some of you get it. Those tires are shipped pressed flat as possible...
-
Mule Meat replied to the thread Tired. . ..I could come and move that Jeep to my place and I won't charge you anything. Then you can put the tire on the right side unless you...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy