Recent content by Murray Edgar

  1. M

    changing 6 volt to 12 volt on massey harris 33

    To Mike in Mn. I have instaled new altenator and coil etc. on my 33 massey. It starts better than it ever did. This tractor was bought new in 1956 by my Dad. And I can still see father coming up lane with it. Question. whtat about altemetor. it is charging beautiful.Do I need to change it,,The...
  2. M

    changing 6 volt to 12 volt on massey harris 33

    Mike thanks for reply. your advice is all I need to know Murray
  3. M

    changing 6 volt to 12 volt on massey harris 33

    I need a wiring diagram or someone to tell me how to connect wires. It is positive ground and and I have positive ground alternator and a new coil. thanks Murray
  4. M

    Faulty hydraulics on 2130 john deere

    Even when the 3point hitch is not in use and in the lowered position, the loader arms and bucket do not operate smoothly. We use trans hydraulic oil but not a JD product. Does this make a difference? Have not had a look with light yet, but will. We are always checking fluid levels and keep trans...
  5. M

    Faulty hydraulics on 2130 john deere

    Even in the summer time when the 3point hitch is generally lowered and or not in use, the loader raising and lowering is not a smooth operation. Tipping and raising the bucket itself is affected aswell. We use trans hydraulic oil. Does it make a difference if we are using not JD oil? Have not...
  6. M

    Ford 8n 1952

    We recently inherited this tractor, runs like a charm.but the 3 point hitch arms will not raise
  7. M

    Faulty hydraulics on 2130 john deere

    loader is lifting even.It has jerking action and than seems to take a hold.With the snow blower raised to maximum height the loader will not lift.It is a John Deere loader installed by John Deere.This problem has been getting worse.(Canada)If the filter on bottom of transmission was changed...
  8. M

    Faulty hydraulics on 2130 john deere

    Front end loader will not lift evenly. Oil is topped up
  9. M

    8n Ford tractor

    Gerald Got it running. Faulty positive cable on battery. Looked good but not good Thanks for help Murray
  10. M

    8n Ford tractor

    Gerald Followed your advice, as I was fiddling at this I noticed a small arc at the positive cable end. Your right this was the problem. as soon as I replaced the end, it started right up andruns like a swiss watch. Simple little solution to complicated problem Thanks again Murray
  11. M

    8n Ford tractor

    Thanks again. I will try this on a wasrmer day. Very cold up here in Ontario
  12. M

    8n Ford tractor

    Thanks Gerald With my untrained I thought it was something like that.How can I trouble shoot this? Looking for'd to your reply Murray
  13. M

    8n Ford tractor

    It has been running good.When the starter button is engaged, there is no response what soever.No response on the amp gauge either.(12volt) I jumped the starter and it spins over good but there is nothing on the amp. gauge. Anybody have this happen? Thanks Murray
  14. M

    MH33 difficulty restarting

    The tractor is difficult to start after engine is warmed up. I have instaled new 6 volt battery and gave it a tune up. Any body have any hints.
  15. M

    MH 33 installing starter switch

    I installed starter switch on my MH33.There is a wire coming from the amp. gauge to the starter switch and I cannot remember which cable it attaches to (the negative or positive) I cannot get spark. I think this has something to do with it. 9
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top