Recent content by Naber

  1. N

    63 4000 hyd remote valve

    I have similar problems with the remote hyd valve on my 4000. I can't find any instructions for setting up this valve in my operator's manual. What is the proper way to set up this valve for one-way or double ports?
  2. N

    Cat Grouser Pads

    I picked up 75 of these grouser pads years ago and have been sitting in a pile. They appear to be unused. I don't think they were ever put on and show no wear. They say Caterpillar on the front side. On the back there is a number 3 B 2778. I measure the 4 inside bolt holes as 11 1/4 in...
  3. N

    4000 serial no.

  4. N

    4000 serial no.

    Thankyou!
  5. N

    4000 serial no.

    I have a newly acquired Ford 4000 with a 4 speed transmission and a Sherman 3 speed. I believe it is a 1964 model. The serial number is: 4110 I-S 46512 What else does this serial no. mean?
  6. N

    961 fan belt

    I need to replace the fan belt on my 961 with a narrow front end. The power steering is gone. Is there a trick to getting the belt off and getting a new one on? It appears that I need to take the pully off to replace the belt. On my 981 with a wide front end it looks like there is lots of...
  7. N

    ford 801 selecto speed transmisson

    I have a 981 with an SOS that I would like to convert to a 5 speed and I am in Nebraska. Could you let me know your contact info or send an email. Maybe I can buy it from you.
  8. N

    Farmall 560 gas

    I have a IH 560 I got a couple of years ago. It appears that it has not had the best of care but it has always started good until now. I checked a spark plug and it looks very poor. It is a Champion # D 21. Would you recommend that I replace it with the same plug or a different plug...
  9. N

    Farmall 560 gas problem

    I meant there is "no" fuel getting into the sediment bowl, not "now" fuel! I should have proof read it. Sorry!
  10. N

    Farmall 560 gas problem

    My problems always seem to happen at the worst possible times. My 560 quit running and wouldn't start again a couple of evenings ago. It was getting dark and I was about to head home but I ended up leaving it in the field overnight and walked home. It snowed about a foot overnight! Now the...
  11. N

    IH 806 battery question

    My 806 has the two 6 volt batteries. Once again they do not have enough juice to turn over the engine. I use a trickle charger to keep the batteries up but I seem to have regular problems with low or dead batteries. I charged both batteries and they both have 6 volts or more according to my...
  12. N

    961 shifting problem

    I bought a Ford with a 5 speed transmission and a 2 step clutch a month ago. I believe it's a 961. It has worked great and I have used it alot with no problems until now. It suddenly won't go into gear, just grinds. The PTO still works as it should. Shifting seems to work fine with the...
  13. N

    D-14 starting problem

    It's a 6 volt with a generator. I'll check the points again. Thanks!!
  14. N

    D-14 starting problem

    I am having a problem starting my D-14. About a year ago I replaced the plugs, points, cap, wires, points, coil, etc. It has been starting poorly but I got by until this summer when I have been coasting it downhill to start it. Then it started missing. Now it won't start at all. It appears...
  15. N

    900 Selectospeed problems

    Larry, you are correct. It is not a 900. I believe it is a 981, serial no. 62147. It is a gold demonstrator model that someone repainted. I will have to work a little harder to figure out if the PTO will turn under a load. I will post what I find out. Thanks!
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top