Recent content by nathanialbumpo

  1. N

    9n run away rpm

    This past winter I changed the clutch on my 9n, while I had it apart I also changed the head gasket (leak on outside of head). Now this may have nothing to do with my problem, but I did have to take a lot of stuff apart to change these items. When using the tractor under load the RPM...
  2. N

    Looing for a front loader DB990

    Been looking for a front loader for my David Brown 990, any out there?
  3. N

    MF1100 3 point hich

    Thank you for the info, logged onto site and found the diagram I was looking for. Ed
  4. N

    MF1100 3 point hich

    My Girlfriend owns a 1974 MF1100 and the pivot shaft where the lift arm is attached to the lower back of the tractor is broke. The hitch/drawbar assembly is some kind of convertible unit that has a latching mechanism that swings under the bottom of the tractor to change drawbar configuration. I...
  5. N

    Kobota G4200 fuel pump

    Well I did all that, checked all that, then went to YouTube and watched a guy repair the injector pump. After seeing how it was suppose to work I figured it had to be the problem. Both plungers were stuck, cleaned and lubed everything and 40 minutes later It was purring. The original fuel...
  6. N

    Kobota G4200 fuel pump

    OK my pump is working, I have fuel to the injector pump, I have both lines off going too the fuel injectors. No fuel is coming out of pump, BAD PUMP? Other than what I am doing is there any other way to test pump?
  7. N

    Kobota G4200 fuel pump

    OK new pump is installed, I got fuel to the bleed valve on top of the fuel pump but nothing coming out tubes going to injectors. Right now I have the injectors tubes completely off and I am not seeing any fuel at top of pump. Is there another vent I should be opening to get fuel into pump. I...
  8. N

    Kobota G4200 fuel pump

    Looks like they sent me a bad pump.
  9. N

    Kobota G4200 fuel pump

    I picked up a kobota G4200 with a diesel engine a couple of years ago. For two years it ran great, put it away for the winter and the following spring I went to start it up, it ran for 10 seconds and died. Turns out it was getting fuel. Checked all the lines fuel ran freely but pump wasn't...
  10. N

    Converting 9n/2n front wheels/tires to wider tires?

    Are you looking to sell them and what size tire will fit on them I am looking for a wider tire than the originals.
  11. N

    Converting 9n/2n front wheels/tires to wider tires?

    Is it a direct conversion with the 8n hubs?
  12. N

    Converting 9n/2n front wheels/tires to wider tires?

    I read somewhere that there I could change out the front hubs on my 1942 2n to except a wider tire. Any suggestions?
  13. N

    990 rear wheel gearbox lubrication

    Do the two gearboxes at the rear wheels require 90w gear oil or are they lubricated by the hydraulic system. I found two large plugs but the instruction book is vague on this point.
  14. N

    Bleeding the hydraulic system on a JD400 loader

    I borrowed a JD400 gas, industrial model loader. I just finished replacing the shaft seal on the power steering pump. I had to remove the oil radiator and the cylindrical tank the flows into it. (hydraulic fluid was getting into crankcase thru a bad shaft seal) Drained and Replaced all the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top