NDIHC's latest activity

  • N
    NDIHC replied to the thread Member.
    He's been on the site today responding to posts.
  • N
    NDIHC replied to the thread Tie rods for Allis Chalmers D14.
    I can't see tie rods making a tractor steer hard. If it was dry spindles or thrust bearings it should have steered hard before the new...
  • N
    NDIHC reacted to Rich'sToys's post in the thread What did I miss? with Like Like.
    I don't get any alerts or notifications. When I log in, any threads with new content are in bold print. The others are not. When I...
  • N
    NDIHC replied to the thread Patching a HDPE water tank.
    I have used JB Water Weld on plastic. So far it has held for a couple of years. I also used it on a tractor radiator where a hose clamp...
  • N
    NDIHC replied to the thread 3 point pin for a JD 709.
    I don't suppose it would be hard to make one. Buy a bolt the appropriate length, cut off the head, weld a flange at the right place...
  • N
    NDIHC replied to the thread Old Shop Tricks.
    Didja notice that all of the cars looked a little "off"? Like the round tail lights in the place where the rectangular or oval 67 impala...
  • N
    NDIHC replied to the thread 1987 Ford F 350 Transmission.
    I've had a few older granny gear 4 speeds that I'd have to give a couple of stabs with the shifter or slip the clutch a bit to get the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top