Recent content by NW-FLORIDA

  1. N

    Workmaster 45 exhaust size.

    What size exhaust flapper do I need for workmaster45 exhaust pipe?
  2. N

    1952/8N side distro-Trans Oil question

    QUESTION: My oil pressure gauge shows 80 psi at idle then pegs out 90 PSI when given throttle. Although it smokes can PSI really be this high?
  3. N

    1952/8N side distro-Trans Oil question

    Yes I understand two different issues. Trans oil drain was separate question.
  4. N

    1952/8N side distro-Trans Oil question

    Got my 1952/side distro tractor started. Some smoke when giving gas fast. I let it warm up well and still does this? Recommendations for this issue? I did put Marvel Mystery Oil in gas. Will this cause smoke (blue)? I check hydro oil and its full. Color looks good. Would you recommend just...
  5. N

    Smoking 8N

    Send me email about the fix as well? [email protected]
  6. N

    1952/8N Start up questions?

    I hit it with PB Blaster and got it to move somewhat. This tractor started up really quick after sitting for 10+ years. Very happy.
  7. N

    1952/8N Start up questions?

    What about the implement lever being extremely hard to move??
  8. N

    1952/8N Start up questions?

    Yes sir-I did remove the old gasket and replace with the one that came with new filter. I took it all out and inserted it all back in. Putting oil in canister with new filter can cause this? Cause I did put (some) oil in canister with the nee filter
  9. N

    1952/8N Start up questions?

    Could be right. I’ll get back into it tomorrow and follow up. Thanks sir.
  10. N

    1952/8N Start up questions?

    Gasket rimg is up top correct? Yes I put new one in
  11. N

    1952/8N Start up questions?

    1952-8N 12 volt conversion. Ok it started up fine and ran fine. Ran for 2 min and I noticed alot of oil coming out of oil filter cannister on left side. I did replace gasket and filter. Do I need to open up again and recheck filter or ? 2. When I tried to life 3 point hitch the handle on right...
  12. N

    1952/8N Grill

    Thank you. When I took it apart I didnt see how it came apart (mistake)
  13. N

    1952/8N Grill

    So push the two tabs up top then loosen up the dog legs on bottom and squeeze it in?
  14. N

    1952/8N Grill

    Need help. Getting 8N back together. Any secret to getting grill back in! I have hood on with all screws in. Did I miss a step?
  15. N

    1952/8N Hood bolt size

    Trying to get correct size for the 4 bolts that hold hood to frame. Holes located under steering wheel area. Manuals are on order.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top