(800) 853-2651
SHOP NOW

Recent content by oldiron48

Yesterday's Tractor Forums
  1. O

    1929 regular

    I have a 1929 regular I am trying to save. where is the best place to find a carb kit and other engine parts. thanks in advance.
  2. O

    1929 regular

    I have a 1929 regular with some worn out parts in the engine and I would like to know what is difference between a regular and a f20,f30 engine parts. and what will interchange. thanks in advance
  3. O

    1929 regular

    are replacement sleeves still available for a 1929 regular and if so where can I get them. thanks in advance
  4. O

    820 2cylinder

    I am bring A 820 two cylinder back to life and the problem is that their are no timing marks on the flyhweel. I would like to know the best way to locate TDC on the flywheel so I can set the injectors and valve clearance.
  5. O

    LP tank filler valves

    Looking for a source for new replacement LP filler valves for a 730 John Deere also fuel cut off valves that go inside the dash thanks in advance.
  6. O

    730 LP strainer gasket

    looking for a LP strainer gasket P/N F1130R Johndeere says no longer available, looking for replacement or source any ideas.
  7. O

    regular

    I just found a farmall regular and I do not know very much about them, I am a green guy. so I need help to find overhaul kit for the engine and carb also where to find any other parts that I might need. thanks in advance.
  8. O

    820 / 830 Center Main Bearing Bore

    I just pulled the crank out of my 820 same problem all three main bearings fried ,turned the crank .020 under on all three mains called MANITOWOC MOTOR MACHINING,MANITOWOC,WI PH 920-684-8577,they have bearings in stock.
  9. O

    hard starting 2350

    I have a JD 2350 and have trouble starting it,if you just start it the starter just bearly will turn it over,if you turn the steering wheel back and fourth it starts easy, any help would be great.
  10. O

    Aged 50 something

    63 in july
  11. O

    720 clutch driver

    the clutch driver disk on my 720 LP is loose well worn out and the splines on the crank have some wear,does any one make a under sized disk,or what is the best way to fix it
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top