(800) 853-2651
SHOP NOW

Recent content by PeterM

Yesterday's Tractor Forums
  1. P

    John Hopson, TN in jail !!!

    Good work! We are on to a Rob Swartzlander doing the same thing.I read`a post the other day, he scammed someone else. Hopefully he reads this post.
  2. P

    Voltage regulator

    Are there different voltage regulators for a 2 brush or 3 brush generator. It is a 6 volt system.
  3. P

    Parts never recieved

    WANTED! Rob Swartzlander from Watervliet MI . We sent him money for parts. He said he shipped them .A month goes by still no parts. He tells us the parts were quarantined by the post office, because they smelled of gas.He tells us he will ship them again.Another month goes by, then another...
  4. P

    Tractor parts never recieved

    Just like to say, this person advertised his parts on Yesterdays Tractor.
  5. P

    Tractor parts never recieved

    Sent Rob Swartzlander, from Watervliet MI, money for parts Dec 15, 2007. March 9, 2008 still have not recieved parts. Payed by paypal.
  6. P

    Fraud

    We sent money by Pay Pal.It is hard to believe it would take almost 90 days to ship a part.We ship parts every week.
  7. P

    Ford 555B Backhoe

    I bought mine new in 87. Changed the oil every 100 hrs. Motor developed internal oil leak into water at 5000 hrs . Replaced motor. Front loader mounts prone to cracking. Rear swing pivot cylinder mounts ,if worn , you would have to have it removed and bored. A little under powered.
  8. P

    JD 950 wont start

    Make sure the compression release handle is in . It is located below the dash on the left side.
  9. P

    massey 44

    Thanks Clutch. We have an odd shaped 2 piece c-clip we are trying to squeeze together. Anyone seen one of these.
  10. P

    massey 44

    What is the trick on getting the two piece clip on the shaft, on the hand clutch?
  11. P

    I-14

    It is the part that goes from the output shaft on the steering box to the draglink ,on the steering system.
  12. P

    I-14

    Would anyone have, or know where we could get a pitman arm and a draglink to fit our 14? Thanks!
  13. P

    International I-14

    We need pictures of the electrical system.
  14. P

    International I-14

    We are restoring an I-14.Would like info and pictures to help with our project. Any and all info would be greatly appreciated. Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top