(800) 853-2651
SHOP NOW

Recent content by peteyrose

Yesterday's Tractor Forums
  1. P

    430-441

    i will have a parts book where would be the best plaace to get one?
  2. P

    430-441

    well got out there and removed the mower and the lift arms will come up with no load and i noticed when the lift leaver is all the way up the pump makes a loud whineing sound but if u move itdown just a littel it stops is this normal?is the dip stick in front of the seat the only place to ad...
  3. P

    430-441

    thanks Joe can i rebuild the pump or better off replacing it?
  4. P

    430-441

    thanks ,i did check the fluid level and it was fine,this tractor also has extra hyd remotes so thay would have to be removed also is that wright ?
  5. P

    430-441

    how hard is it to change the hyd pump in a case 430-441.I was using it to cut hay with no problams but when finished on the way out of the fiald the lift when to the ground and will not come back up thanks for helpimg
  6. P

    430-441 lift

    what would make the lift arm stop working,it has fluid and was working fine thanks for the help
  7. P

    5000 ford

    thanks soundguy its not so bad it cznt be lived with,and to ultradog if u dont now how to fix it dont worry about itim from the south and thats just the way i spell if u dont like it dont post on my stuff.
  8. P

    5000 ford

    what makes the three point hitch jump from time to time can it be ajusted ive cleaned the screen put in pto clutchs resealed the pumps get this should have finished thanks for advice.
  9. P

    5000 ford

    thanks for the info will post on the ford foram
  10. P

    5000 ford

    The three point hitch on my 5000 ford has a constent jump to it is there a way to fix this
  11. P

    5000 ford voltig regulator

    well i never did think of it yesterday but today i reved up the eng and gen light went off hope this is fixed,thanks again for the info will remember this thanks
  12. P

    5000 ford voltig regulator

    thanks will give it a try,
  13. P

    5000 ford voltig regulator

    i installed a new voltig regulattor but was told it has to be energized is this wright and how do u do this ,is there a esey way to change the brushes in the genarater on this tractor thanks for all help
  14. P

    431 maybe

    thanks joe for the info i woundered about the leaver that sounds wright.the eng turns over good but has set out side for about 4 years and the carb is froze up but other then the grill and seat every thang else is there hope there askin 900.00 for it and a 6ft bush hog i dont think that to bad.
  15. P

    431 maybe

    i am looking at a what the owner is calling a 431 case but im not sure.it is a gas eng no power steering but has one set of hyd hookups and the rear wheeles do slide out.it also has a lever on the left side of the bell housing thay say it works like a T.A.iv ran 430s befor but not sure on this...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top