(800) 853-2651
SHOP NOW

Recent content by Phil N

Yesterday's Tractor Forums
  1. P

    Allis Chalmers model "G" oil seal on belt pull

    https://www.amazon.com/Precision-Automotive-450244-Seal/dp/B00A8CHO2M Go to above site. Great Price!
  2. P

    Wd-45 thermostat wont fit

    Click on Below and take your pick: https://www.rockauto.com/en/catalog/international,1977,scout+ii,5.0l+304cid+v8,1175138,cooling+system,thermostat,2200
  3. P

    Wd-45 thermostat wont fit

    Get a 180 Degree thermostat for a 1977 International Scout with 304 V8 and it goes right in with no adapters. Piece O Cake.
  4. P

    Secret to Starting a 2N in the Cold Weather

    My tractor DID sit in the weather for a few years before I got it and the inside of the Carb casting had some rust. I did a carb clean up and rebuild kit. I missed the passage in green in the picture in my earlier post. It ran OK but started hard, especially cold starts. I took the carb apart...
  5. P

    Secret to Starting a 2N in the Cold Weather

    Notice in the Carb cutaway picture, there is a small passage starting at the bowl gasket parting line and goes straight down to the atomizer tube passage (shown in green ). The carb casting is made of cast iron and this passage gets rusty and gets partially or completely blocked causing hard...
  6. P

    Old Ugly 8N

    Quite ugly but functional.
  7. P

    8N Battery Question

    https://www.ebay.com/itm/283338243372?hash=item41f8467d2c:g:jSAAAOSw~VBcO93A Click on above and put on a battery disconnect. There is also a style for side terminal batteries.
  8. P

    Cultivator for 8N

    https://www.google.com/search?rlz=1C1ZKTG_enUS888US888&sxsrf=ALeKk025py1QjM9-h9Btr4GR7fk7MD9ECg:1625691031471&source=univ&tbm=isch&q=Images+of+Belly+Mount+Cultivator+for+Ford+8N+Tractor&sa=X&ved=2ahUKEwi-1ceD69HxAhWJT98KHVd_Ah0Q7Al6BAgEEBU&biw=1366&bih=657 Click on above for some ideas.
  9. P

    8N and Planter Fasciitis.

    https://www.ebay.com/itm/124667565557?epid=23025659059&_trkparms=ispr%3D1&hash=item1d06c415f5:g:d5kAAOSwnoJgalPZ&amdata=enc%3AAQAFAAACcBaobrjLl8XobRIiIML1V4Imu%252Fn%252BzU5L90Z278x5ickkp2NA0WuhQytmt4dbStg00FfYmHal6qSBECVyDEKHEt5pUPRviH03cJqEQid91DY99Vxl%252BEEiBbvQvp0Lk3ko7yAID9TJhefRAm2hLvh5NSv...
  10. P

    9n issues

    All the previous suggestions are very good. If you have a Marvel Shebbler or Zenith Carburetor, the cast iron housings have passages that rust shut over time without use. There's one or two passages that go through the gasket surface between the float bowl and main casting. They can rust over...
  11. P

    Mystery Hardware

    The inventor of the original starter drive was Vincent Hugo Bendix. That's where Bendix comes from.
  12. P

    Mystery Hardware

    https://en.wikipedia.org/wiki/Bendix_drive#:~:text=The%20device%20allows%20the%20pinion,its%20inventor%2C%20Vincent%20Hugo%20Bendix. Click on above. This is where the "Bendix" term coms from.
  13. P

    Mystery Hardware

    Starter Drive Part. Where did the term BENDIX come from anyway??????????
  14. P

    Alright, which one of you owns this BEAUTY?

    We got 30" of snow in Central Vermont on Thursday. Without this beauty, we never would have gotten out.
  15. P

    Jubilee 3 point working off FEL pump

    Unlike the 9N, 2N, and 8N, I'm quite sure the Jubilee had 3 separate oil chambers in the drive line. Transmission, Hydraulic, and Rear End. Guys, correct me if I'm wrong. See attached cutaway view. Sure looks like 3 separate reservoirs to me.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top