(800) 853-2651
SHOP NOW

Recent content by Poonie

Yesterday's Tractor Forums
  1. P

    What size belt for this old woods mower?

    Yes it has the original mounts, but the two lower rear pulleys are fairly new. They're about 5 inches in diameter. The original pulley is still on the PTO. I'm wondering if NAPA would sell such a belt?
  2. P

    What size belt for this old woods mower?

    I'm trying to rig up this old woods mower deck to my farmall cub. The mower is beat up but still rotates fine. It's about 4 foot in diameter. I have the belt that came with it but it's pretty trashed. I couldn't find a part number on it so hoping one of you guys might know. Thanks.
  3. P

    Wood deck trailer owners, protecting the surface?

    I've got a flatbed car hauler with a wood deck. I've been protecting the wood from the elements with clear Thompsons water seal. I reapply about every 6 months as this trailer lives outside. Is there a better product to use, and what are you using?
  4. P

    Difference between A and Super A, and a good place to find decals for these tractor

    I got my decals from Steiner. Most of my parts I get from them, or here in the parts section.
  5. P

    How do I remove this piece from my cub?

    Disregard...... I needed to remove just the oil seal. I thought I'd need to remove this plate to press it out. I found a seal puller in the bottom of my tool chest that I had bought years ago and never used it. Was still in the packaging. I tried it and sure enough seal pulled right out.
  6. P

    How do I remove this piece from my cub?

    The triangular piece in this photo. I need to install a new seal however it won't come out. I thought removing the three bolts would allow removal but it's not budging.
  7. P

    Towing?? ;-)

    I volunteered at our local airshow years ago and they towed a B25 Mitchell bomber with an F250. Truck pulled it with ease.
  8. P

    Seeking advice for underground wiring

    I used to have 12 volt floodlights going out to my flagpole. I simply buried the wire underground without running it through any conduit. Works fine but eventually the connections will corrode and you lose power. Got tired of fixing it every four or five years, so disconnected it one spring. I...
  9. P

    Two brand new LEDS bad from the box..

    Not surprising. With everything being made in China these days, where quality control going to America is nonexistant, you're lucky to get anything that works.
  10. P

    Preserving old tractor AS IS

    I've used a mix of diesel and motor oil maybe a 70/30 mix, sprayed on using an spray bottle that fits to an air hose. Saw this guy named Marty t on you tube use it on his tractors. Does a nice job of preserving and shining up the metal. Just don't spray it on the seat or steering wheel or you'll...
  11. P

    Cub surges when running.

    I cleaned the main jet then rain the engine for about 15 minutes at varying throttle settings. The surging seems to have gone away.
  12. P

    Cub surges when running.

    My cub has a Zenith carb. I've cleaned the main jet before. I'll pull it again and see if that's the issue.
  13. P

    Cub surges when running.

    What would cause this? I ran my cub up and down the road the other day and it started surging. It surges even at idle. Could it be a clogged or partially clogged jet, choke butterfly opening and closing? Not sure. Any help appreciated.
  14. P

    Chinese mini excavator, anyone know the adapter sizes for the hydraulic thumb?

    Our local hydraulics place didn't have them. They're pretty much SAE and that's it, the clerks words.
  15. P

    Chinese mini excavator, anyone know the adapter sizes for the hydraulic thumb?

    I actually did find this same video yesterday. I found some on a hydraulics website so I ordered two. I bought this thumb off Ebay as it was cheaper than even Amazon. Of course meant it came in a beat up cardboard box, with no plywood bottom and top as most I've seen do. Plus, no adapters. I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top