(800) 853-2651
SHOP NOW

Recent content by prairiecarr

Yesterday's Tractor Forums
  1. P

    Pinion gear

    Glad you found most of what you need. Bearing for this model will be a challenge. After five months I have found all the bearings in the transmission and differential.
  2. P

    Finally finish the RTU

    It looks really good. Glad the battery worked out. I am still trying to find parts for the one I am working on. The first one I done 12 years ago I could get anything I needed. Boy, it different now.
  3. P

    Pinion gear

    Need a good pinion gear for a 1948 model R. It is a seven tooth pinion gear and ten tooth spline on shaft. Have checked a number of Minneapolis salvage places with no luck. Hope someone here might have one.
  4. P

    11/7 Very Special

    Happy birthday Ann!
  5. P

    Wednesday Tractor 10/7

    I remember BMB in Hilton .
  6. P

    RTU battery

    Montidale, let us know how that 19L battery works. I will need a battery in a couple months. l
  7. P

    RTU battery

    I read that an old 6 volt for VW bug is correct. I think it was group 19L but I am not po stive.
  8. P

    Is there anyone yet around who rebuilds tractor steering wheels?

    EverGreen Restoration has an ad in Farm Collector that says they do steering wheel recovering. 715 520 7876.
  9. P

    RTI Military

    Fly the flag!
  10. P

    R transmission bearings

    molinegb, thanks for looking.
  11. P

    R transmission bearings

    Good thought. I will have to try it. That’s why I like this forum, you guys have ideas I haven’t thought of.
  12. P

    R transmission bearings

    Yonson, that info is correct. The problem, the reason for replacement is rust. The tractor is only going to be used for shows or parades, so the owner, my brother ,wants to polish the shafts and put new bearings in and call it good.
  13. P

    R transmission bearings

    Thank you yonson, if my measurements are accurate it is 2 1/2 inch. I will pursue the number you provide. If when, I finally get it out may have a number on it.
  14. P

    R transmission bearings

    Thank you montidale, for your reply. I have those manuals. The double race is driven out to the rear but the front side taper is flush with the case casting so I can’t get get a driver on it or even a punch.
  15. P

    R transmission bearings

    I am working on refreshing a 1948 R series. It is the third one I have played with but the first one that I have had to go into trans and rear end. I need help with part number for the small roller bearing between the clutch shaft and upper sliding shaft. I came up with 94518 Hyatt but I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top