(800) 853-2651
SHOP NOW

Recent content by QueFan2

Yesterday's Tractor Forums
  1. rusty6

    2140 JD and snow

    Had a few heavy snow spots in my yard so I thought I'd get them cleared up a bit this evening. I have to say that the front end loader is not great for clearing roads. Takes forever as the snow keeps running off each end of the bucket. If I was going to do much snow removal with it I'd adapt a...
  2. F

    Bad splines : How much time do I have left, Doc?

    :( Had to deliver bad news to one of my patients today. I said it is terminal and at best you have 100,000 seconds left. :roll: ruffly 27 hours but nothing is certain at this point I've seen them stripped before I've seen them bad but never one like this the splines are curled over...
  3. E

    B john deere rear end oil?

    I have new 85w-140 oil in my 43 B John Deere rear end. Is it alright to use in 20-30F degrees or should I drain and put 80w-90 in it for the winter? Thanks for your help!
  4. C

    Feeler gauge set

    Went to check points & rocker arm gaps today. The feeler gauge set, that I found, has two numbers on each feeler and the end is ground some. like .018-.020. Does that indicate the tip is .018 ? What's the reason of this type gauge. Thanks
  5. H

    John Deere 720 hat

    Looking for a John Deere 720 hat
  6. jon f mn

    Today's Funny

    .
  7. 1

    Case 500 plow

    Looking for a 4 bottom spring reset
  8. F

    1953 Ferguson TO-30

    Hi all, first off I've always been able to get my tractor running, but this problem has me stumped. I've owned it for 10 years now and it started acting up last summer. It started choking itself out and running very rough being choked like it was. I parked it after I installed the back blade for...
  9. K

    Steam Cleaners

    Wondering if anyone has tried using one of the smaller household steam cleaners to clean an engine of caked on oil/grease? A quick search found a Wagner steam cleaner and a McCulloch steam cleaner online for around $150. Just wondering if they have the output to clean an engine. Thanks.
  10. B

    656 vs. M axle diameter

    does an 656 have the same axle diameter as an M. got me a 656 today and it has press steal centers. I have an extra set of cast centers on a M parts tractor. thinking about changing them out if their interchangeable. Also, got me a set of 455 4 row cultivator mounted on my M. what a...
  11. G

    hay tedder/fluffer

    Hi everyone. I recently bought an old but heavy 2 basket tedder. No tags. I am guessing European made because when I replaced 2 bolts, they were metric. 10 tines per basket. They flail out when the PTO is engaged. The wheels have 3 adjustments up/down. Has a spring loaded travel position. I...
  12. D

    S motor question

    I parted out an SC and am in the process of dismantling the engine. Ready to pull the crank tomorrow. My question is how do I get the Magneto drive and governor off. I now have two SC engines. This ones free but has a crack in the block. I have another SC engine that was running when I took it...
  13. N

    What?s it worth?

    This is a Ferguson plow, going for auction Saturday. I don?t need it and would have to clean it up and paint it. I am thinking $150 would be a fair high bid. It is a 1 1/2 hour drive too. Thoughts?
  14. F

    IMT 542

    Tractor engine rings frozen but isn't locked up. I can't find anyone that can rebuild engine. I either need a replacement motor or I need to sell it so I can purchase another tractor so I can put in food plots. I've had the tractor for 15 years and this is the first time I've had any problems.
  15. D

    Old Threshers Reunion!

    Anyone going this weekend! Been I think at least 10 years since I have been. Might go again!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top