(800) 853-2651
SHOP NOW

Recent content by rainman4820

Yesterday's Tractor Forums
  1. R

    MF 265 Steering Issue

    Thank you for the info, I will grab a #6 JIC fitting and gauge and give it a try.
  2. R

    MF 265 Steering Issue

    Thank you for the responses - as an update, I operate the tractor daily as I use it extensively on our farm. The power steering issue continues to be erratic. Steering becomes difficult, I check and the reservoir is low and I add fluid and then 30 minutes later steering becomes difficult and...
  3. R

    MF 265 Steering Issue

    Anyone have experience with power steering issues?
  4. R

    MF 265 Steering Issue

    I have a confounding issue with power steering. I had a considerable loss of power steering and was low on fluid so added about a pint. This happened again and again or a few days so I assumed another leak. (Same thing happened 2 years ago and I had the seals in the steering cylinder replaced...
  5. R

    MF 265 issue bleeding after injection pump gasket replacement

    Did exactly as you prescribed and she started up ! I just want to say thanks for taking the time to share your expertise. Your efforts saved me money and time but more importantly, gave me a chance to have a deeper understanding of how these machines work...always looking for an opportunity to...
  6. R

    MF 265 issue bleeding after injection pump gasket replacement

    Thank you for the quick responses!
  7. R

    MF 265 issue bleeding after injection pump gasket replacement

    Edited my post to note that I did not go through the entire pump, just replaced the throttle and stop o-rings and lid gasket so i don't believe timing is an issue.....Just finished replacing gaskets and reinstalled pump. I opened the bleed nut on the top/side of the pump and pumped the lever...
  8. R

    MF 265 Hydraulics Question

    Thank you for the clarification and labeling, I agree this will be helpful to get this issue resolved. Any additional thoughts on the “control lever for the aux hydraulic valve”. Is this lever in any way related to the hydraulics that currently control the loader function or is it for other...
  9. R

    MF 265 Hydraulics Question

    I should have been more specific when labeling the "control lever" in the drawing - this is intended to depict the control level (raise/tilt) for the loader. A picture of this device is below. Does this answer the question on whether there is a "control valve"? There is no other device...
  10. R

    MF 265 Hydraulics Question

    Thank you for taking time to mark up these photos - see very simple diagram of the hydraulic setup and a picture of where the hoses are connected that supply hydraulics to the loader. I will have a service manual in hand this afternoon and may be able to speak to this issue with more...
  11. R

    MF 265 Hydraulics Question

    Thanks for hanging in there with me - pictures attached It appears that the hyd hoses from the loader move back through the hyd controls and then directly back to the "pump" on the left side of the drivers seat (near the PTO lever). I see nothing on the right side of the seat near the...
  12. R

    MF 265 Hydraulics Question

    Still trying to sort.this out and keep things around the farm moving so I appreciate your comments and patience... Couple of items to clarify - its somewhat irrelevant but the front end loader is a Bison not Buffalo (have a hard time with those 2). Also, I am researching further but looks like...
  13. R

    MF 265 Hydraulics Question

    Thank you JimME - this is a buffalo brand front end loader and I have looked again at the tractor and it appears that the loader uses the factory hydraulics as everything is plumbed back to a pump that is located on the left side of the seat. I agree that the power steering is a separate issue...
  14. R

    MF 265 Hydraulics Question

    Morning all - looking for advice on how to troubleshoot a hydraulics issue - a coup!e of years ago the power steering cylinder set began leaking and was rep!aced. Now there is a leak in the power steering system somewhere as steering gets tough and I have to add fluid, however, now I have...
  15. R

    Massey 265 Power Steering Cylinder Overhaul

    Hello all! New to the group and first post. I have a leak in the power steering cylinder on the 265 and am planning to rebuild. Are there any diagrams or posts that I can use as a guide for removal, rebuild and re-install. Many thanks!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top