-
R
601 workmaster 3 point problems
I would check to see if there is air in your pump. I had that problem on my 600 a few wears ago, ended up having the pump rebuilt to solve the problem. Good luck -
R
gas cap on 1960 861
I put a gas cap off of a 1966 ford truck on my 600 years ago and never a problem. -
Would you reuse a head gasket?
Continental F162 Flathead 4 out of a Massey 101 Jr. I bought the engine site unseen, and am pulling it apart to inspect it. The pistons, and valves look great. When comes time to put it back together, could I use the old head gasket? It's sandwiched steel, with copper inserts around bolts...- stevieb49829
- Post #1
- Forum: Tractor & Farm Talk
-
R
Ford 600 running rough
I have a 600 also, and sometime ago it started acting up just like yours, and I replaced the coil and fixed my problem. Coils are not that expensive. I am sure others will chime in and add their thoughts. -
R
D14 Oil pressure
My D15 gas engine runs at a steady 20 psi and I've had it since 1994 with no problems.- RDobbs
- Post #1
- Forum: Allis-Chalmers
-
R
Ford 800 loses power
My 600 was doing same thing. Replaced coil and fixed the problem. -
R
Ford 861, help with 3-point not rising enough
I have a 600 and about 20 yrs ago it started doing the same as your tractor. Turned out to be the cam pin and air getting into the hyd pump. -
R
Toggle switch
At times it will shut down as if key was turned off. I can jiggle the switch when it starts this and it will be fine for a while. I think it's the switch that came with the tractor in 1957. -
R
Toggle switch
Have a 600 gas 6 volt, and keyed switch has gone bad. Will a toggle switch work as good as a new keyed switch? -
R
1953 Ford Jubilee
I have a 600 and it was acting up just like yours. Turned out to be the 6 volt coil was bad. -
R
Fact or Fiction?
Good information. I think I have learned something. Thanks -
R
600 Oil Pressure
Have owned the 600 for 30 yrs and oil pressure has always held a steady 40 lbs. Recently the oil pressure will start out at 20 lbs then maybe go to 60 then after about 5 mins settle back to 40 lbs and hold. Does this sound like oil pump going out? Oil level is full. -
R
64 Ford 2000 died?
My 600 was acting like this a year ago. I put on a new coil and replaced the keyed switch and cured problem. I don't think you have a gas problem unless it's not getting good vent. jmo -
R
Another 960 followed me home
Nice looking tractor. Good looking front loader too. Looks heavy duty. -
R
1955 600 looses power under a load
I have a 57 (600) and it was acting a lot like yours. The ignition switch was bad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy