Recent content by Red48M

  1. R

    706 MCV issues

    Gbs, The rear end is at least 5 gallons over on the dip stick. Last owner must have tried that. The dump valve seats against the snap ring. I'll pull the relief valve when I get a chance. How do i check direct pump pressure? I don't have access to a flow meter. Thanks
  2. R

    706 MCV issues

    Owen, When the tractor is cold the pressure will spike to about the 270 with the steering held all the way. When it warms up the pressure will go back up to about 235, but the quickly falls back to 215 or so with the wheel held. Thanks.
  3. R

    706 MCV issues

    I recently purchased a 67 Farmall 706 German diesel. The tractor starts and runs great, yet doesn"t like to move. If its cool out it will drive just fine Direct drive and TA until the hyd oil warms up a little bit. Then the tractor wont move at all and the oil light stays on. The steering and...
  4. C

    8n ford firing issues

    ok i recently got a ord 8n and i rode it around yesterday fired right up quick to and today i went to start her and only the plug closest to dash is firing:/ any ideas
  5. B

    Jubilee Steering Box Remove/Replace

    I recently removed my steering wheel so that I could replace the bearing at the top of the steering shaft on my Jubilee. After I got the steering wheel off I noticed that the splines at the top of the shaft were almost completely rusted away. This was most likely due to the tractor sitting out...
  6. M

    8n will not start, tried everything I could think of...

    Hello All, I've had my '49 8N since 2002 and I know my way around it pretty well. It is a 6V system with a chev alternator. Background info: This spring, it was hard to start after sitting for a couple of months so I drained the gas tank and refilled it with fresh gas and changed...
  7. R

    w9 brake bands

    I need one a couple years ago and ended up with one out of a salvage yard. If your metal band is still good I would look into having it re-lined. Good luck.
  8. P

    Flushing a crankcase

    I just flushed the crankcase of my 60 with diesel fuel in a weed sprayer. I removed the crankcase cover and cleaned everything out. The crankcase is very clean. I flushed everything out the drain hole. In the process, did I loosen enough grit inside the pickup screen to circulate it through the...
  9. R

    OT-Lost oil pressure on '93 chev 350. Any idea's?

    I"d say pressure sender, if not then the pick up fell off the pump or the shaft broke.
  10. R

    Case 3 bottom plow?

    <a href="http://s104.photobucket.com/albums/m177/usmcchevy/?action=view&current=P1010046.jpg" target="_blank"></a> <a href="http://s104.photobucket.com/albums/m177/usmcchevy/?action=view&current=P1010234.jpg" target="_blank"></a> <a...
  11. R

    Case 3 bottom plow?

    Hello everyone, I purchased this Case plow and have some questions about it. I plan to fix it up enough for plow days and to put a load on my tractors (M, SMD and W-9). I replaced the rear tire along with put some tires and rims on the front just to get it rolling. I found some shares that I can...
  12. R

    Starter for Super MD

    Thank you everyone for your help so far. The tractor is a 1952 Super MD s/n F 2797J, so that means I need the early starter. So one off a MD will work? I thought MDs used a 2 bolt? Thanks again.
  13. R

    Starter for Super MD

    I recently bought a Farmall Super MD and need a starter for it. Will any farmall 3 bolt starter work? If not what models do I need to look for? Thanks
  14. R

    SuperM diesels

    I might be interested in a Super MD or the 450D for the right price. Where are they at in SD, I'm from southwest MN. Email is open
  15. R

    W-9

    Mine's solid brass too. You can kind of see it in this pic.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top