Recent content by rkoronka

  1. T

    310 case dozer parts

    I have some 310 case dozer parts to get reid of. Who can i sell them to as a lot? I have finaul drive, blade,hydrolic cylenders and asorted parts all from old parts dozer. I hate to take them to savage yard for scrap. Hope someone has interest?
  2. L

    how much oil ?

    I have a yardman riding mower it has a 20 hp briggs and straton intec motor I bought it used and dont have a manual can you tell me how much oil it holds? I should have asked when I bought an oil filter for it but i forgot
  3. A

    International 544 Wheel weights

    I have located some 24" wide int'l flat style wheel weights that were on a Int'l 656 with 38" wheels. My 544 has 28" wheels with only 26" available on the inner portion of the wheel for the weights, and the valve stem sticks out diagonally into that area. The picture of the wheel weights I am...
  4. S

    HOW MUCH GREASE

    FARMALL H WATER PUMP PULLEY HOW MUCH GREASE DO U NEED TO PUT IN "its the fitting with the srew on cap" left side... not up top...TO MUCH IT SEEMS YOU CAN SHOOT GREASE IN BLOCK.I PUMPED GUN 3 TIMES.THANKS FOR ANY INFO
  5. R

    450 jd b injector trouble

    I have a jd 540 b with a rolla master injector pump. It will not shout off with the key switch.I think it may be a wire problem or what do you think guys?
  6. R

    450 jd dozer

    My dozer will now not shut off with the key switch. I bought it with the top wire on the alt. clip on the side of the alt. not hooked up.When I hooked the wire up to the key switch post where the terminal has no voltage when the key is off.I have to get a screw driver and short the injector pump...
  7. R

    450 jd dozer

    The dozer is a 450 b.The top wire is on the alt. clip that pluges into the alt. side, one of the wires goes to the big bolt on the behind of the alt. ant the other goes to the key switch I think.
  8. R

    450 jd dozer

    I hooked my alt. top wire on alt clip to the key switch when the key is off no 12 volts on that termanal. the key will not know kill the tractor to turn off the engine. I have to short the injector pump wire to stop the engine at the pump.Did the key switch go bad? Thanks for any help!
  9. R

    idiot light stays on

    I have a 2510 jd tractor and the idiot light stays on. The belt is tight and the alt. shop checked the alt and said it was fine. The wires are hooked up top wire on clip is on the key switch when key is hot. the bottom wire and the wire on back of alt are tide together and go to the starter bolt...
  10. R

    2510 jd idiot light on

    My 2510 jd alt. was checked at a shop and it is fine. the top wire goes to the key switch , the bottom wire and the wire on the bolt behind the alt. are tighted together. Is this right? Idiot light will not go off alt belt is tight. Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top