(800) 853-2651
SHOP NOW

Recent content by Robert J Hampton Sr.

Yesterday's Tractor Forums
  1. R

    injector adapter

    what size of injector adapter will i need to check compression on a 245 Diesel??
  2. R

    245 hard to start in cool whether

    what should be an acceptable number on compression for my 245??
  3. R

    245 hard to start in cool whether

    maybe so. I could not ask for mine to start any better in the warm months and runs just fine.
  4. R

    245 hard to start in cool whether

    Ok. I have looked around and some say check compression with injectors in and some say remove which is it? thanks
  5. R

    245 hard to start in cool whether

    My 245 deisel is harder to start when the temp is in lower 30's. Starts rifgt up in summerbut in winter acts as though it is flooded and white or gray smoke. any suggestions what the problem is. I have clean the tank and put fresh fuel, filter, and air filter on.
  6. R

    245 engine

    I was looking for a injector pump for my 245 and got the numbers off of my pump but I can not read the numbers for the engine size and that is apparently what i need. How many different size engines were used in 1977 for the 245 massey??
  7. R

    245 massey steering

    I have checked the front end of my 245 and everything seems tight but there still some free travel in the steering. what else should i check?
  8. R

    rear work light

    I have a rear work light on my tractor it has two wires, and a two way toggle switch. can someone tell me the correct wat to hook up the wires both are red.
  9. R

    tach question

    I removed the tach cable from my 245 while painting it. When I put it back on the tach is acting weird going all the way around an jumping any advise??
  10. R

    leaking injectors

    how do you check injectors to see if they are leaking??
  11. R

    King Pin??

    What is the best way to check for wear in my king pin? I have a 245 massey ferguson.
  12. R

    clearcoat ??

    I used agco machinery enamel. It is what the MF dealer in my area sells.
  13. R

    clearcoat ??

    alkyd enamel with hardener.
  14. R

    clearcoat ??

    what is a good brand of clearcoat? I have painted my red parts red on my massey and am satisfied with the results. How long should I wait before aplying clear to fresh paint. any tips on clearcoat welcome.
  15. R

    CLEANING UP

    What is best to clean up the gun after painting with Alkyd enamel with hardener? I also would like help finding the pictures of a restoration I have seen on here before but cannot find it was of a 245 Massey ferguson.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top