Recent content by Robert Plyler

  1. R

    run-away-engine

    Finally got my engine back in my tractor after a rebuild. The last thing I did was rebuild the carb and fired it up.It started just fine but the engine kept accelerating. I pushed the throttle all the way up and it slowed down.When I let it go the engine ran up again. The throttle does not seem...
  2. R

    12 volt coil with internal resistor

    I know I've seen it somewhere on this forum but I cannot seem to find it now. Can someone give me the part number for a NAPA coil that I can use without having to use a resistor? I have a TO30 converted to 12 volt. Thanks
  3. R

    new wiring

    Richard, Are you going orginial or switch to a 12 volt? If you are going orginial I have a brand new harness around here someplace that I cannot use. I ordered one for a 12 volt conversion and the guy sent me this. If you think you can use it let me know and you can have it as I have no use for it.
  4. R

    fan belt

    What size fan belt does my to-30 tractor use? It was already converted to a 12volt system when I purchased it. The alternator pully looked like it came off of a lawnmower deck and was worn out. When I bought a new correct pulley the belt is too wide. My belt looks to be 3/4 wide and does not fit...
  5. R

    alternator pully

    What size alternator pully does my TO30 tractor use? The belt measures 3/4 wide. I dont know if this is correct or not. Any help is appreciated.
  6. R

    resistor

    Would someone explain to me what the resistor on my to 30 does. the tractor will run without it but I wont because I know it has a good reason for being there. Thanks
  7. R

    Z134 oil drain plug

    Bill,Try All States AG Parts 1-877-530-4430. They were able to help me with a TO30 oil pan plug that got missing during my rebuild. Good Luck
  8. R

    Plug Wires

    I ordered custom plug wires for my TO30 and upon receiving them noticed they were stainless steel core. The discription did not state that fact and I was surprised when I received them. I have read on this forum that copper wire is the way to go. Should I reorder or see how the stainless wires...
  9. R

    OIL PAN PLUG

    I misplaced my oil drain plug for my TO30 during my engine rebuild. Does anyone know what thread it is or does someone have an extra one that you would sell. Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top