(800) 853-2651
SHOP NOW

Recent content by ROGER A. BROWN

Yesterday's Tractor Forums
  1. D

    52 B head

    Question,Will a 1953 50 cylinder head fit a late 1952 B?
  2. R

    Using 3 point auger on a TO20

    Thanks for all the suggestions. I was checking the auger tip, it looks pretty rounded off from much use. Do y'all think a new tip will greatly improve the digging? I viewed a new tip and it looks to be pretty square at the ends. Also, I think the auger is frozen up on the tube coming out...
  3. R

    Using 3 point auger on a TO20

    I am using a TO20 with a Leinbach auger for punching some post holes. Since the Fergy doesn't have positive down pressure, any suggestions for either putting weight on the auger or what have you. I see a hole in the gear box head that I think used to have a solid steel bar in it that was...
  4. R

    Ferguson TO20 fuel sediment bowl

    Is the fuel sediment bowl on the Ferguson TO20 interchangeable with a Ford 8N? Mine is cracked and I need a new one, but I don"t want to buy the whole assembly, just the bowl. Thanks!
  5. R

    Front wheel bearings on a TO20

    Are the front wheel bearings on the TO20 interchangeable with the 8N or 9N? I need to order some as the bearings are grinding on one wheel. I figured since I had it up in the air, I might as well do both of them. Any help is appreciated. Roger
  6. R

    chains

    I made some using turnbuckles, with a hook and eye set-up. The turnbuckles cost about $12 each. I then ran a chain around the lower control arms and ran a grade 8 bolt thru that. The turnbuckle allows you to adjust your "hog to just the position you want. I did mine because I had a slow...
  7. R

    Valve guide replacement

    I think I need to replace the valve guides on my TO20. I have a fouling problem in the #3 cylinder and I think the valve guide is worn and letting in the excess oil. Anyone have an idea on how difficult this replacement is? I saw one post, but all it mentioned was removing the spark plug and...
  8. R

    Brush cutting

    I have a TO20 and had problems keeping the mover deck at an even level due to a slow leak in the hydros. My solution was to buy two turnbuckles at the hardware store, hook on one end, eye on the other, and chain them to the lower lifting arms. With the turnbuckles, I am able to control and...
  9. R

    Ferguson TO20

    I have a 49 TO20. Fouling on all plugs, especially #3 cylinder. I am considering converting to 12 volt. Right now, I cannot get it to start. It cranks and cranks, gets spark, but no go. How difficult is it to do a conversion to 12 volt? Also, which spark plug is recommended for the TO20? I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top