(800) 853-2651
SHOP NOW

Recent content by Ronnie G

Yesterday's Tractor Forums
  1. R

    Hydraulic Lift Forks

    Lift arms & yes knuckles. Leveling box top side how it attaches to lift arm. Part# 9N566 Knuckle, Master Parts Catalog for 2,8,9Ns & NAA page 12..
  2. R

    Hydraulic Lift Forks

    Trying to install new lift arms. Shaft is moving back & forth as I try to put on new arm. Super tight fit.
  3. R

    8N Left Brake petal shaft almost frozen

    The zerk fitting is for the left side clutch pedal. The clutch pedal works great.
  4. R

    8N Left Brake petal shaft almost frozen

    Petal frozen to begin with. Took a sledge hammer to be able to move it. Shaft must be rusted. Clutch on shaft works fine. Tried to grease zerk on lest hand side shaft. Squirted PB Blaster on inside shaft on both side. put torch on inside both ends, no help. I can manually move brake petal up &...
  5. R

    No Oil Pressure 1950 8n

    This is for all you "know it all" people, let"s really see if you know it all. Purchased an overhauled bare block from Iowa. New oil pump kit, new governor. Fired up like it was supposed to, no oil pressure.The oil pump was pre-lubed and so was the oil pressure relief hole, forgot to mention...
  6. R

    Oil bubbling out dipstick tube when engine running

    Head scratcher, 1950 8N, gas did not flow through carb to oil pan. Water has not leaked from head into oil pan, dipstick reads just below full mark. Engine non smoking. Oil pressure 20 lbs when running.Who wants the gold ring? Any suggestions?
  7. R

    proper hog engagement....

    Shredder first, brings it up to speed
  8. R

    8N 1950 Front Mount 8N Headlights

    1/2" impact driver will zip em right off, quick & easy.
  9. R

    8N Oil Pump losing prime

    I just finished a 2n restore had same issue. Pulled pan, checked P/U tube, pump, no issues. Removed pressure relief valve, the pin was ok. Streched the spring about 1/2 inch, put back together, 35 psi, steady pressure.
  10. R

    Governor

    No, they do not interchange. The 8N has two levers, the 2&9N have three levers.
  11. R

    Fuel Tank

    There are two ways to keep the radiator cap from scratching the hood. If anyone is interested, shoot me an email. Cheap way costs .50 cents the other way cost 10.00. Ronnie link_disallowed
  12. R

    Solenoid screws?

    Yes, they are..
  13. R

    One wire alternator....

    Amen Tommy, I put on over 20-1 wire alts, no issues or worries at idle...Knock Knock. I also have a special 3 wire to 1 wire adapter, for those pesky 3 wire alternators..
  14. R

    tire/rim question

    Yes, they are. The part number is: C5NN1050E
  15. R

    Manifold Gaskets

    It's not neccesary, won't hurt but not neccessary
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top