Recent content by Rons b

  1. R

    8N ignition coil

    my batteries are up to charge and have the correct voltage at the coil. Im hoping its the new plug wires that are the cause and ill try that tomorrow. thanks for all the help.
  2. R

    8N ignition coil

    It is a 6 v system. Im asking the ? about the resister only because this is what it said on the box for the coil. It said the coil is for without an external resistor meaning the coil is internally resisted. One thing is saw in the tips was the need for copper core plug wires. the set a got...
  3. R

    8N ignition coil

    I'm working on a friends Late 8N with distributer on the side I cant get it to fire. I tested the coil and it was bad. Installed a new coil wires points condenser and have a spark but its week. I tried putting a jumper direct from battery to coil and still the same, the coil said without...
  4. R

    Voltage Regulator

    Adding a ground wire was one of the thing I added during my diagnosing to make sure. thanks for the help
  5. R

    Voltage Regulator

    I have a B with a new 4 wire regulator. It was not charging and after going through diagnosing the problem I figured out that the coil in the regulator was not pulling in so it wouldn't charge. It would pull in if I jumped from the A Terminal to the Bat on the Reg while it was running. I...
  6. R

    Model B noise from the Governor

    So I wanted to pull the complete governor off because the gasket was leaking. Pulled all the parts off and then was taking the oil line from the underside in the crank case and the line fell off. There's the problem. The oil line assemble from the oil filter head to the cam was broken off. Why...
  7. R

    Model B Spark Plugs

    The b is still starting with ease and I put the tractor through its first workout. We had are first rain for the winter and after it rain is when I can drag 2 miles of graveled road. The B had plenty of power and never bogged. it would loose traction first and now I need to get some weights. The...
  8. R

    Model B noise from the Governor

    The one thing I didn't take apart during the restoration was the governor because it appeared to be OK. With the workout it started to leak oil at the left side of the base so it may be getting oil but I'll check the oiling system. Thanks for the info
  9. R

    Model B noise from the Governor

    To access the weight do I need to remove the complete assemble or can it pull the shaft from the left side.
  10. R

    Green magazine

    Is it a mirror image. everything is reversed
  11. R

    Model B noise from the Governor

    Would it be the pins and or the weights that are worn and slapping around. The noise just started it wasn't a gradual increase in noise
  12. R

    Model B noise from the Governor

    I gave my 46 B its first workout today and it was working great but the last few minuets it started making a ticking noise from the governor. I could hear it from both sides. Any ideas what it mite be. Thanks
  13. R

    Model B Spark Plugs

    They cost $7-$9 each. You can buy them from there site e3sparkplugs.com
  14. R

    Model B Spark Plugs

    I thought I would try some of the E3 Brand plugs in my 46 B They don't make a plug that crosses over to the Autolite 3116 I went with the only plut they have with the correct thread. It fits Ford motors from the 50s - 90s. Part # E37.2 and you need to put a crush washer from another plug on...
  15. R

    the B is finished

    Its a 46, luckily it was not in the main part of the fire. I had the motor and axel rebuilt before. The sheet metal got the worst of it. The hood was ok the grill was warped but got it strait and had to go with a replacement battery panels. Thanks for everyone's thoughts of my Father.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top