Recent content by Saintbacon

  1. S

    1980 John Deere 510

    Hi there! I've got a John Deere 510 from the 70s. I was digging out a rock the other day and one of the hydraulic lines that feeds the bucket movement exploded. I got a nice hot oil shower. (Manual image attached with the burst location highlighted) I'm looking to replace the flexible line...
  2. S

    1978 Deere 510-C Diesel Revvs up suddenly

    Thanks for the info DieselTech. It seems like you're definitely onto something. I think you're correct in that the problem is in the injection pump. because as far as I know: 1) The speed of the engine is controlled only by the injector and nothing else. 2) I have 1 control rod that is...
  3. S

    1978 Deere 510-C Diesel Revvs up suddenly

    Hey there. Got a JD 510-C. This problem just started today. Basically I'll be doing something nominal like lifting my bucket or pushing it into the ground at a low RPM (Near Idle). Suddenly the tractor decides to go FULL THROTTLE and the engine revvs up to what seems to be max. The strange...
  4. S

    1978 Deere 510-C Diesel Revvs up suddenly

    Hey there. Got a JD 510-C. This problem just started today. Basically I'll be doing something nominal like lifting my bucket or pushing it into the ground at a low RPM (Near Idle). Suddenly the tractor decides to go FULL THROTTLE and the engine revvs up to what seems to be max. The strange...
  5. S

    IH 3600a (656 Hydro Trans) No charge pressure

    Hi there! I've posted before but figured I'd provide an update. I've got a 3600a TLB that just won't go into reverse and the hydraulics are sluggish. I ran a bunch of tests but most recently I've discovered that there doesn't seem to be any charge pressure ~AT ALL~ coming out of the...
  6. S

    International 656 No Reverse!

    Another update - Capped off both the high pressure forward and reverse lines in order to be sure the problem was inside or outside the transmission. Unfortunately the same exact issue is happening. I went through pretty much every post containing the phrase 656 and came across some old posts...
  7. S

    656 hydro no reverse

    Hey there Andrew! I have the same transmission in a 3600A tractor that uses the 656 transmission. You describe the problem EXACTLY the same as what i'm experiencing. Were you able to get this resolved? Thanks!
  8. S

    International 656 No Reverse!

    So quick update. I did another adjustment on the adjusting block inside the transmission. Now, when I press on the reverse pedal, the tractor lurches backwards just a little bit. It stops moving almost immediately, but every time I press on the pedal, it does this same lurch. It almost seems as...
  9. S

    International 656 No Reverse!

    Appreciate the advice Al! I'll give it a shot.
  10. S

    International 656 No Reverse!

    I do not believe the foot operated models have a drive control valve - at least as named. I attached a few more pictures if anybody wants to review them for ideas. Basically the pump servo doesn't seem to want to go down into reverse all the way. Thanks if anybody else has ideas!
  11. S

    International 656 No Reverse!

    Thanks Used Red - I reached out to Herrs just now. I'll see what they can do. I did peruse the Hydro help article too but I'm not sure it covered the same problem. Appreciate any other ideas folks have. I know Jim Naden replied to a few related things on this site and was hoping he might be able...
  12. S

    656 Hydro dying?

    I wanted to see if this solved the problem for Tim, but the post is showing up strange. Sorry! Tried to delete this to no avail. This post was edited by Saintbacon on 09/27/2021 at 12:06 pm.
  13. S

    International 656 No Reverse!

    Hi there - I've posted about this problem, but I've done a good bit of research/testing since then so I feel like I can ask the question in a more intelligent way. This is an international 3600a (It uses the 656 Hydro transmission, which is where I suspect the problem actually is)...
  14. S

    3600A No reverse

    Bit of an update. I opened up the bottom of the hydro transmission. Doesn't look like there's any foreign material in there, and honestly it looks gorgeous inside. I was halfway expecting a crusty old pile of junk. So there are 2 pistons in there that seem to control one of two swash plates. I...
  15. S

    3600A No reverse

    Hey folks. Thanks for all your advice and suggestions so far. I'm trying to tackle the next problem on this backhoe loader. No reverse. . This is a hydrostatic transmission with 2 pedals - one for forward and one for reverse. Pushing on either pedal seems to work the linkage properly which...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top