Recent content by SaveMy50

  1. S

    MF 35 Multi-Power Hard Shifting

    Thanks, end of season coming up so i'll have a look at the clutch adjustment, hoping not to have to split this tractor
  2. S

    MF 35 Multi-Power Hard Shifting

    So drove it this weekend, and in Low range, no PTO load, shifted fine. I wonder if this issue is mainly under PTO load, as I run in High mode on slopes to use the engine brake, but try to switch to Low mode when not on slope, but after a bit, the shifting issue starts even in Low mode?
  3. S

    MF 50 No Spark

    Solved, I think, replaced condenser stud that stripped (not fully tightened) inside distributor, then replaced coil with an oil filled one previously bought (and lost in shed, but that I could measure continuity across +/- connectors and across +/center wire hole), then found all spark plug...
  4. S

    MF 35 Multi-Power Hard Shifting

    Apology, I could have been more clear, it didn't matter that I was in High or Low, it kinda locks up, until I rock it, but maybe I will look a bit closer at coming to a stop in Low more often?
  5. S

    MF 35 Multi-Power Hard Shifting

    Gas, starts and runs great. Had clutch done couple years ago, getting hard to shift, locks in gear almost, particularly when using PTO (mower, baler), and even in high mode when engine brake is not on. Seems more recently. But it will shift easily and normally if I rock the tractor a bit, clutch...
  6. S

    MF 50 No Spark

    Now cannot get a resistance continuity across the coil + & -, so appears have to replace. Why might this new coil only run the tractor for 2 minutes (as noted above)? Work in progress ....
  7. S

    MF 50 No Spark

    So cleaned points with $ bill, Confirmed it was a new A&I Products A-21A513 coil, listed as 12V with internal resistor, at least as shown on package container, But still no spark even though 12.5V to the coil (+). I will bring a test light next time. Also still to confirm fuel flow, but spark...
  8. S

    MF 50 No Spark

    I did not clean the new points, will do that. I will try test light on the (-) of coil to distributor. I will test drain fuel again at the carb. I will get the coil type I installed confirmed.
  9. S

    MF 50 No Spark

    Follow up: coil shows resistance between +/- pole and much higher between + and center plug. Made sure continuity from Negative side coil thru to points connection inside distributor. Was checking for spark on #1 plug, nothing for 30 seconds then spark, so I connected and it started. But it only...
  10. S

    MF 50 No Spark

    MF 50 Gas w/ Alternator - tractor was shutting down after 10-15 minutes operation, figured coil (since it was really old), so replaced, along with new points, condenser, rotor, cap, but now I can't get it started. I have power (> 13v) to the coil, but no spark at plugs or even points (with...
  11. S

    MF 50 Unknown Shutdown

    Thanks for responses. Shouldn’t be gas cap, as I just changed to a vented one, and minor gas splash on top of tank I think confirms it’s venting, but I’ll try running loosened. It was originally a 12 V system, generator based. I installed alternator directly to battery. But I did not...
  12. S

    MF 50 Unknown Shutdown

    Gas, Z134, Alternator installed, I had previous posts about hard starting but it's better now (may have been a fouled plug). Latest issue is unknown shutdown, after running for a bit (> 20 minutes). Can't tell if something overheating (coil, condenser?), but it didn't seems a fuel issue (no...
  13. S

    MF 50 Hard starting

    So got around to starting without fuel cap, no change, still took multiple tries, did notice after a few tries the odd time back pressure to the air system (minor oil spurt up), so don't think its a cap issue. Did adjust power needle out 1/4 turn cause governer wasn't kicking in on minor hills...
  14. S

    MF 50 Hard starting

    It’s always been hard to start, with slightly slower cranking speed compared to my other MF 35. New starter. Gas tank, bowl and screen filter cleaned, carburetor TSX 683 kit done, initial needle settings both 1 turn out, good flow out of carburetor drain when opened. I haven’t adjusted...
  15. S

    MF 65 Gear Slipping?

    Really only the right side sounds like it slips. I have the manual, so guess I'll be pulling the axle off (this winter)?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top