(800) 853-2651
SHOP NOW

Recent content by Scott430

Yesterday's Tractor Forums
  1. S

    201g engine

    I took a 201 out of a 660 combine and bolted it right into my 430 utility and just have to lengthen the top cover oer the engine. no big deal, bolted right up no mods to engine needed.
  2. S

    430 steering cylinder issues

    anybody have a clue where I can find this information I am seeking?
  3. S

    430 steering cylinder issues

    I tore into the steering assist cylinder yesterday and found in just neeeded a good cleaning. O rings are good, spool and body is good. I reassebled and was wondering how much "throw" the control should have to activate the spool. The slot is around 1.5 to 2 inches (guessing) long, but the ball...
  4. S

    Case 430 w 201 gasser problem

    Just to let you know, I had to turn my distributor about 60 degree or so, and the tractor fired right up, no ether. Thank you for your input, you deserve a giant gold star! I'd buy you a beer if I could! Thank you
  5. S

    Case 430 w 201 gasser problem

    Okay guys, tractors running great. Not sure how, but the timing was off. I actually removed the distributor, check the gear, looked like the distributor has not been removed since built. The pertronix must have somehow slipped time or whatever however, but that was the problem. I sure do...
  6. S

    Case 430 w 201 gasser problem

    Yes, it appears my choke moves correctly in and out, and the flapper corresponds to the settings
  7. S

    Case 430 w 201 gasser problem

    I purchased the coil that pertronix reccommended for this set up, it's typical of a 12 volt can style coil. I'm not sure how to test the voltage at the coil, can you advise?
  8. S

    Case 430 w 201 gasser problem

    Adirondack: I have the pertronox electronic ignition installed in my distributor. it eliminates points and condensors. Which is the same problem I was having before switching it over was continuous points and condensors problems. It works like a charm up until just before this winter, and lately...
  9. S

    Case 430 w 201 gasser problem

    dbeiter: I know it is in fact a prestolite distributor, not sure exactly which one though. It used to run great with minimal start up issues, but lately it's been a real pain in the arse if you know what i mean. Do you think the plate spun? if I recall there are 2 screws that hold it down...
  10. S

    Case 430 w 201 gasser problem

    would you happen to know what to check for as for as settings on this motor? I have the pertronix ignition on it.
  11. S

    Case 430 w 201 gasser problem

    The starter cranks the motor just fine, and I give it choke and nothing happens, have plenty of spark, fuel is getting to intake, I just tried ether and it stopped the motor dead during cranking... Not sure what this is a sign of, maybe some of you guys can help me with this problem
  12. S

    quick attach for loader

    I am searching for something I have seen on skid steers, it's the quick attach system used to interchange buckets rakes spears forks. Anybody know if they make them for my 430 Case loader tractor?
  13. S

    Hazmat endorsement

    I have kept my endorsements even though I don't use HAZ at my current job, it's still a nice option to have to fall back on. The Haz test wasn't too difficult 15 years ago with a little studying, not sure how it changed since then. A few years back I had to get fingerprinted to keep it. Our...
  14. S

    Positive ground? Negative ground?

    Okay, so the smaller steel line that comes out of the front of the diaphragm I just replaced may be plugged? If I'm understanding you right that is. I'm going off the top of my head here, I don't have the tractor near me so to speak, so I will have to get to my uncles place and take a look at...
  15. S

    Positive ground? Negative ground?

    Thanks John, I will look into this.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top