(800) 853-2651
SHOP NOW

Recent content by slat

Yesterday's Tractor Forums
  1. S

    Swapping rims

    Will rims from an Allis D17 fit a MF 65?
  2. S

    Electrical field

    Thanks for the response. That"s what I thought it was. Just wanted to make sure.
  3. S

    Electrical field

    My MF 65 wasn"t charging after doing some research I was going to see what if any voltage was being put out. Problem is every time I even tried to get close to the tractor with my VOM while it was running the display just started flashing random numbers. I didn"t even touch the probes to...
  4. S

    3pt lift

    After a little research and trying a few things this is where I'm at. Position control doesn't do anything. Draft will lower 3pt when brought up and raise 3pt when pushed down. Any ideas?
  5. S

    3pt lift

    I put in a new hyd. pump and a different lift cover. My lift arms come up about a third of the way and just stop. What adjustment might I need to make? Anything I should be looking for?
  6. S

    GL rating for a 1958 MF 65

    Thanks for the replies. I found some 90 weight GL-1 at a local farm supply store. It said it was Ford hydraulic fluid for older Ford tractors. Label said it was S.A.E. 90 GL-1.
  7. S

    GL rating for a 1958 MF 65

    I talked with someone at a local oil supply company and they recommended Mobil 224. http://superiorpetroleum.availablecandidatelist.com/html/mobil_eal_224h.html It looks like it might work. Any opinions?
  8. S

    GL rating for a 1958 MF 65

    What GL rating should I have in my 65? Does or will it matter if it is GL-1 or GL-5? I know it needs to be 80w90 or straight 80 or 90 gear lube. Just wondering about the rating. Thanks Steve
  9. S

    gaskets

    Would there be a problem installing the paper gaskets on the rear axle housing if the temp is below freezing? I know you have to soak them in water, but will that effect them if they are installed and then freeze? Didn't know if the pressure of being installed would keep them ok.
  10. S

    Bearing shims

    Do you know anyone that does reasonable priced machine work. I need to shim up that bearing but it may need to be put on and off a couple times to make it fit right?
  11. S

    Bearing shims

    Yes I do. Why? Somewhere I'm over looking?
  12. S

    Bearing shims

    Thanks Chuck
  13. S

    Bearing shims

    Does anyone know where I can find the bearing shims for the planetary on a MF 65? They aren't available from the dealer. Tahnks
  14. S

    Brakes locking up

    Thanks. Will make sure it is cleaned up well before I reassemble everything.
  15. S

    Torque specs

    Does anyone know what the torque specs are for tightening the trumpet axle housing, the planetary, inspection housing and the wheels on a MF 65?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top