(800) 853-2651
SHOP NOW

Recent content by SteveM

Yesterday's Tractor Forums
  1. S

    Ferguson TO35 Temperature Gauge

    Thanks all, much appreciated. I tried drilling it out, but hard to get at it, so I pulled off the thermostat housing and worked it loose from the inside out. Came right out. And I can confirm the part scoobieguy referenced above does indeed fit. Thanks again!
  2. S

    Ferguson TO35 Temperature Gauge

    Recently bought a 1957 TO35, and the temp gauge doesn t work. I ordered a new gauge, and got the old gauge out of the dash, but in trying to remove the sending probe, it broke off. Any advice on getting the probe out of the housing? Also, I m reading online that there is confusion about...
  3. S

    Ferguson TO35 Temperature Gauge

    Moved to the Harry Ferguson forum , after I realized there was a separate forum, sorry. Mods can delete. This post was edited by SteveM on 07/27/2022 at 11:44 am.
  4. S

    135 . STUCK IN REVERSE

    Bit of a newbie here, but I recently had the same problem, albeit mine was stuck in 3rd. Based on advice from another forum online, I was able to access the shifter forks through the transmission fill hole, and easily slide the out of position shifter fork back into position using a screwdriver...
  5. S

    135 . STUCK IN REVERSE

    Bit of a newbie here, but I recently had the same problem, albeit mine was stuck in 3rd. Based on advice from another forum online, I was able to access the shifter forks through the transmission fill hole, and easily slide the out of position shifter fork back into position using a screwdriver...
  6. S

    TO 35 Stuck in 3rd Gear

    It worked! Once I knew what to do, it took all of ten seconds! I can t thank you both enough!! And you can bet I will shift more slowly and methodically from now on! Thanks again, Steve
  7. S

    TO 35 Stuck in 3rd Gear

    Thank you!
  8. S

    TO 35 Stuck in 3rd Gear

    Thanks for the reply! I have the filler cap off, and have a decent view of the insides, but not sure which is the 2/3 shifter fork that I need to move. Since I don’t have a service manual for this tractor, I’ll poke around on the web and look for a diagram of the transmission. Once I figure...
  9. S

    TO 35 Stuck in 3rd Gear

    Hi all, I have a 1957 TO 35 with a dual range 3 speed, that’s stuck in 3rd gear. The shift lever seems to be in neutral position, but won’t move in any direction. I’m told I may be able to free it up through the filler hole, but not sure how to attempt this. Any advice? Thanks in...
  10. S

    Need a shift lever for a Ferguson...

    It snapped off just below the cover, and it looks like it fatigued and broke off. I don't remember doing anything out of the ordinary at the time, just shifting. But until I installed a 12 volt conversion, it had been difficult to start for some time. Perhaps the repeated attempts to start it...
  11. S

    Need a shift lever for a Ferguson...

    Hi all... I have a Ferguson TO-30, from around 1954 I think, and I broke the shift lever recently. Got it apart, and it"s broken just below the inspection cover. Having trouble finding a replacement. Anybody here have any ideas? Thanks, Steve
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top