(800) 853-2651
SHOP NOW

Recent content by SteveR(OH)

Yesterday's Tractor Forums
  1. S

    8n brakes

    I get tired of fighting with the axle seals. I replaced once and it seemed like in no time, they leaked again. I had an extra set of drums, so I drilled some holes in a set. I thought that reduced area would give a little more friction and help, not to mention it might keep oil from...
  2. S

    Ballast resistor

    ok. Will get another coil. Thanks All~!
  3. S

    Ballast resistor

    side
  4. S

    Ballast resistor

    Need opinion. Tractor is converted to 12 volt but I don't think there is a ballast resistor. I burned out a coIL that was not very old, and said right on the side no resistor required. Do I need one anyway?
  5. S

    naa steering bearings

    Yeah, all the contours are the same. I guess I will put both new bearings in and hope for the best!
  6. S

    naa steering bearings

    I have an NAA with a bad top bearing on the steering shaft. I bought top and bottom, plus the very top bushing and spring. When I look at these new bearings (I bought em here) the just don't seem to want to fit in the bearing race like I expect. Maybe I expect them to act like tapered roller...
  7. S

    Can Jubilee steering box be rebuilt pretty easily?

    shoot. I hope I won't need to take my shoes off. :(
  8. S

    Can Jubilee steering box be rebuilt pretty easily?

    A local (maybe a loco?) tells me I have a bad bearing in the bottom of the steering box. Its really hard to steer, and it does that thing where you can see the steering wheel raise and lower a little as it fights on the internal threads. I'm not ascared to tear into it, but am looking for a...
  9. S

    too much juice

    I need to borrow the multi meter again and see. I sort of recall it being around 16 V.
  10. S

    too much juice

    [email protected]
  11. S

    too much juice

    I'm sure its a voltmeter. This is on a jubilee, by the way. I have seen conversion kits where there is an external resistor as part of the kit. I am not sure I see that on my tractor (although I need to look again). Anybody have opinion on the necessity of such a resistor?
  12. S

    too much juice

    I bought a tractor that had been converted to 12v, and it started to overcharge the battery. I was advised the single wire generator has a built in regulator and that was the issue, so I replaced it. Same. Still pegs the volt meter over 14 volts. Cooked a battery Was told to run a...
  13. S

    overcharge!

    I bought a tractor that had been converted to 12v, and it started to overcharge the battery. I was advised the single wire generator has a built in regulator and that was the issue, so I replaced it. Same. Still 14 volts. Was told to run a ground wire from generator housing to the...
  14. S

    rebuild front distributor

    Any suggestions on where to get the rebuild kit?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top