(800) 853-2651
SHOP NOW

Recent content by Tdubbels

Yesterday's Tractor Forums
  1. T

    3010 carb issues???

    I took the carb off the tractor. Before I took it off I sprayed some brake clean On the gaskets and the throttle/choke shafts. When I took it apart I might have bent one of the float pontoons but after I measured the height it was only 5/8 and its supposed to be 1 5/8. The accelerator piston...
  2. T

    3010 carb issues???

    I dont have the carb off the tractor yet, I will do that tonight when I get home. I have the idle adjust at the recommended starting point but I have the load only about half a turn out and that seems to get me the best results, I was thinking the gasket going to the intake manifold might be...
  3. T

    3010 carb issues???

    I will definitely replace both the accelerator pump and check valve. Should I also replace the accelerator jet or emulsion tube. I found this kit on the internet and it has the acceleration valve, pump and jet. Its kind of pricey but it includes everything but the two cast carb pieces and...
  4. T

    3010 carb issues???

    ttps://forumphotos.yesterdaystractors.com/photos/mvphoto66257.png[/img] I might call the dealer tomorrow and see if they have a better kit or if I can get the acceleration parts and gaskets.
  5. T

    3010 carb issues???

    I have a 3010 with a zenith 12510 carb. It starts and runs decent. My complaint is it will smoke very excessive when you have a constant load on it and you suddenly lesson the load it will puff some smoke. it will also smoke if you do a quick acceleration. I feel like it has a high fuel...
  6. T

    3010 wheel weights

    I was thinking that I might need one set for sure, Ive seen some pictures of tractors doing well in similar looking soil with no weight but I dont know if they had fluid in the tires or not. A semi mount plow is supposed to put the down force of the plow on the rear tires right?? So I...
  7. T

    3010 wheel weights

    The tires are currently not filled with fluid, or at least the last time I filled them the valve stems were low on the rim and no liquid sprayed out. I looked at the pictures online and I found this page in my tractors operators manual.
  8. T

    3010 wheel weights

    Come on this is a show tractor I need originals. I looked up part number R61524R and R61727R but I didnt see any that said they were for a 3010 R61524R was made for the 20-30 series I believe. Im almost certain that they would fit but I dont want to look like a fool at the shows
  9. T

    3010 wheel weights

    I noticed that the picture I tried to post earlier didnt post Hopefully it works this time
  10. T

    3010 wheel weights

    I miss him also. Its hard to believe that its been 10 years already I talk to his brother Dave quite a bit (That's where I get to see all the cool hidden treasures).
  11. T

    3010 wheel weights

    Yes I'm his grandson! I will look in the operators manual on the tractor and the plows manual when I get home. I Probably won't be doing any plowing his fall anymore unless this dang winter weather lets up like last year.
  12. T

    3010 wheel weights

    I have a 3010 that I plan to use to pull my 3-16 f145a plow, I was wondering what would be a good recommendation for weight that might need to be added. The ground around here is kind of all over the place with areas with lot of sand and in other areas more silt. We do have a decent loam soil...
  13. T

    3010 PTO questions

    I heard that one of the things deere changed when they came out with the 3020 was the PTO shaft. As long as I make sure the shaft mounting bolts are tight, and the expansion joint on the implements shaft is easily moveable and properly lubricated it shouldnt brake the mounting of the shaft...
  14. T

    3010 PTO questions

    I just bought my 3010 tractor a few months ago and this is the only tractor of that era that my family has. On the rear of the tractor it currently has the 540 pto shaft in place. It has a 1000 shaft in the font of the transmission case under the operators platform. I read in the operators...
  15. T

    JD 60 Light Switch Off I L B D

    Yes I do have the flat top fenders with the four front lights. When I turn it to L the inner front lights are on and then rear red light. When I turn it to B all four lights come on and the white reverse lights. When I turn it to dim all four front lights turn off and only the rear white light...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top