(800) 853-2651
SHOP NOW

Recent content by terry kane

Yesterday's Tractor Forums
  1. T

    help with john deere g pullen

    Not good little brother. i will b back to take care of super m.new 14" rims going on.havent pulled yet with these ajustments .but your day has come.
  2. T

    help with john deere g pullen

    Most of the time 6 to 9 feet.he has the same tire as me brand new.but on 14 inch rims.he runs with 11 pounds air pressure.i put 10 in mine now and shortened draw bar .28inches from center axle.i think the wider rim will help.but more money to spend but worth it to shut him up.the super m has 57...
  3. T

    help with john deere g pullen

    This snounds a lot like what its doing.going to try it and see what happens.I ajusted my rpm up little more to get more speed in 1st gear .just tryen stuff to beat this super m of my brothers.got a pull commen up at the fair maybe i will get a win under the lights.b a 1st for me a lot of money...
  4. T

    help with john deere g pullen

    Have a 1952 john deere g. flat head bored over .090 64 hp dyno. have new 14x9x38 firestone feild road tires on 11 inch rim.cant get a good bite.hitch set at 18 inches high just shortend draw bar.10 lbs air in tires .how do i get it to hook up.need to beat brothers super m .havent yet. need help
  5. T

    1952 JOHN DEERE G WITH FLAT HED

    Thanks.dont have the money to buy new head.but someone sait to put a 3/8 bolt in water jacket with lock nut on excaust side.dont no what they mean .going to try new gasket and tighten it tight see how it holds up.
  6. T

    1952 JOHN DEERE G WITH FLAT HED

    FLAT HEAD HAS A LEAKING GASKET. ANYWAY TO FIX OTHER THEN GETTEN IT PINED
  7. T

    john deere g tires

    seem big to me . most go with 14.9-38
  8. T

    john deere g tires

    ok u pull what do u think of the 15.5-38 goodyear DURATORQUE R 1 . WAS GOING WITH 14.9-38 TITANS.ALSO WILL THE 14.9-38 MESS WITH GEARING BECAUSE OF HIGHTH.THANKS TERRY
  9. T

    john deere g tires

    going to put new tires on my 1952 john deere g.whats a good size and brand tire to go with for pullen.was going with 14.9-38.but others say 15.5-38.thanks need help to out pull sumper m my brother got.
  10. T

    1952 ford 8n clutch replacement

    got new clutch and pressureplate for 1952 8n. on the clutch disk does long end go towards fly wheel or rear of tractor.reason for replacing no clutch pedal.tryed to adjust did not help it. i put a new clutch in it about 22 years a go with my dad.worked till now.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top