-
Tgrasher replied to the thread Silo for Saturday.It most probably would have had a feed bunker with an auger distributing the silage down to the end. -
Tgrasher replied to the thread Case 530ck torque tube leak.It's most likely that the seal is not made anymore, but rather two seals of the same size will replace it, one facing in, one facing...
-
Tgrasher replied to the thread Case 530ck torque tube leak.Thought about your oil transference problem for a day and can't come up with anything but a leaking rear main seal. Went to my books...
-
-
Tgrasher replied to the thread Poison Hemlock.Here, it is spread by mowing. The State DOT road maintenance time their mowing so that the Hemlock and Johnson grass are full of seed...
-
Pulled off 2 days of luck. 45 4x4 rounds on approx. 5 acres. And some of the herd.
-
line both the gear marks with the pointer , forget about the TDC marks on the front pulley at this point, as long as the internal timing...
-
Thank you so very much for the information. This engine has a plate on starter side and that’s where I got the numbers. I’ve looked all...
-
Tgrasher replied to the thread RACOONS IN THE BARN.Take the food supply they're after away and get/borrow a "cat friendly dog" that has some hunter in him.
-
There are several different stem tubes used in these by-pass oil filters. It's very easy to make up a stem tube, some people use steel...
-
Tgrasher replied to the thread In Need Of Advice For Oil Filter Base.The tube is just a piece of 1/4" od pipe and about 5" long. Take a drill bit to stick in hole to check size for sure. Pipe can be found...
-
After cleaning everything up well, I made a lead gasket to put in the valve block. Tightened several times over 2 days and put my disc...
-
Tgrasher replied to the thread crazy casey.Wish I could be of help but can't answer your question except to guess. If you post oo the Case forum I'm sure someone can help. It's a...
-
Good morning everyone I got my big field of first cutting done yesterday. it was about 9 acres I cut on Wednesday. turned out to be a...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy