(800) 853-2651
SHOP NOW

Recent content by thrust

Yesterday's Tractor Forums
  1. R

    G- allis

    got a g allis and need a crankshaft pulley -- any body got one -- ben all over with no luck -- thank you in advance
  2. A

    Good / bad points of a 14T baler?

    Have a chance to get a 14T baler and am wondering if there are any bad points about them? I have heard they are a slower baler but I only bale a little in a waterway occasionally. Are most parts the same on the 24T or after? Do they bale a decent bale?
  3. V

    one wire alternator question

    i have just about finished my 8n side mount dist. rewire project with one wire alternator, however one more question, i have my wire going from the alternator to the ammeter, what else needs to be done on the alternator to make sure it charges my battery? thanks dave
  4. J

    OLD IH TRIP RIPPER

    Anyone have any info on these? Clutch lift like a #8 plow.
  5. J

    Case 660 combines

    I thought I would show some pictures of my 2015 oat harvest. <image src="http://forums.yesterdaystractors.com/photos/mvphoto28015.jpg"/>
  6. O

    4430

    Just a quick question, we are painting a 4430 next, and this would be the first Deere we have done (mainly Olivers). We use PPG paint for the Olivers, what is the most recommended paint to do this tractor with? OEM, or is there something better? If so, what are the codes? Thanks, Adam
  7. M

    Need a hydraulic expert here!!!!

    I'm looking for someone that's extremely knowledgeable on open center hydraulic systems on tractors and combines of all colors. Here's my story.......I have a Massey 5200 articulated 4wd which is same as an old 4000 series Massey 4wd hydraulic system wise from what I've gathered so far...
  8. N

    Garden

    Off to another less than stellar start. Part of the sweet corn did not come up. Watermelon in when it needed to be but the coolness has set it behind. Tomatoes, squash, and cabbage putting along. I want more sweet corn in but everything is too wet. If only I had a little spring tooth harrow...
  9. H

    OT Skunks

    Have a large deck with a distinct odor of skunk coming up from underneath it. Dog has been excited about something there for week or so. Deck is less than six inches high and I cannot see back that far to confirm my suspicions. Any way to discourage it (them) and encourage them to move on...
  10. J

    farmall 400 brakes

    getting ready to replace brake discs. i want to make sure that axle seal does not leak. what is a good way to check this ? i can leave overnite and put paper towel underneath it.
  11. T

    thrush bearings

    Well, since you did it both times you used the word, it would appear that you didn't know it was a THRUST bearing. Yes, he was poking at you, maybe a little too hard, but I'll bet you know now what to call it. You'd look like a real tool if you went to the parts counter and asked for a...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top