(800) 853-2651
SHOP NOW

Recent content by tperson

Yesterday's Tractor Forums
  1. T

    Ultrasonic carb cleaner

    I bought a harbor freight 6L about a year ago and wouldn't be without it. We've cleaned rifle brass, gun parts, countless carbs, tools, jewelry, dental retainers, and just about anything that's dirty that fits in the tank. Amazing. The trick I learned this summer is to fill your bath with water...
  2. T

    hollered at you late last week about the cub gear, but you didnt answer (no big deal). Looking...

    hollered at you late last week about the cub gear, but you didnt answer (no big deal). Looking for a 2nd gear with 72 teeth. Call anytime after 4:30 Central - 402-450-8239
    • tperson
    • Profile post comment
  3. T

    Long story short, my oldest son (16) purchased an early Lo Boy about 2.5 months ago. Now we've...

    Long story short, my oldest son (16) purchased an early Lo Boy about 2.5 months ago. Now we've found the 2/3 sliding gear and 2nd gear are chipped (and the 1st/rev shift fork broke). I was able to find all the parts except 2nd gear...(here comes the plea for help). Knowing your experience in...
  4. T

    ? zero turn for two acres

    PM sent
  5. T

    Paw prints

    take a look at the toe pads. If you draw a line between them, do they cross in the rear pad or before it? Cat tracks will cross on the rear pad, dog tracks ahead of it. I also agree with claws...cats retract theirs, dogs can't
  6. T

    Farmall 656 Gas Engine Options

    https://www.redpowermagazine.com/forums/topic/155286-putting-a-c301-in-a-656-farmall/#comment-1794015
  7. T

    Nettles ????

    you all may laugh or snicker, but try rubbing penetrating oil on the welts. PB blaster, WD40, whatever you have. It'll take the sting out.
  8. T

    IH 300U wiring....last question I hope.

    Sent...I hope
  9. T

    IH 300U wiring....last question I hope.

    Dave - PM me and I'll send you a copy of the operators manual Edit: crap, forgot YT doesn't do PM's. Let me figure out another way for us to email each other without posting our address for the spammers to see. This post was edited by tperson on 07/28/2023 at 08:07 am.
  10. T

    solder stick

    As others have said, this may be because your iron is too small/too cold to heat the joint up quickly. It may also be caused by lack of flux. Slobber a little flux on your ends before you insert them into the terminal or after you've made the splice (I use the paste Ruby Fluid from Ace), hold a...
  11. T

    WARNING TO YT'ers,....

    off topic I know...but I'm just west of Plymouth. We're neighbors (kinda)! Not a native, but a transplant...grew up around Albion
  12. T

    Jump starter packs

    many moons ago at work, someone left a small power inverter plugged into the cigarette lighter of the work truck...for months. Well, when we went to start it, the dome light wouldn't even turn on (D-E-D, dead). The low-cost lithium ion jump pack we had (think $50 harbor freight special) started...
  13. T

    Jump starter packs

    https://no.co/products/power buy as big as you can afford
  14. T

    Lawn Mower tires

    I'd caution you about changing the tire height. As you raise the rear of the mower with a taller tire, you'll change the pitch (rake) of the deck and it WILL affect cutting performance. Before you switch to a 24" tire, make sure you have at least 0.5" [(24-23)/2=0.5] of adjustment on the rear...
  15. T

    premixed gasoline

    In my opinion, the real advantages to canned gasoline is no ethanol and conveniencethat s about it. I have a hard time paying $20/qt for something I can make at home for a fraction of the cost. No, I don t run my 2-stroke stuff weekly and probably only use 1-2 gallons of mixed gas a year in my...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top